0
What else can I help you with?
I want to take out the cat on my 98 2.5L Wrangler. I have an o2 sensor before and after the cat. Could this pose a problem?
It is ILLEGAL to remove the Catalytic Converter without replacing it with a new one.It is ILLEGAL to remove the Catalytic Converter without replacing it with a new one.
Can you remove the catalytic converter on your 98 F150 4.2 six?
2
Why are your lights flickering on your 98 Bravada?
If your lights are flickering on your 98 Bravada, you might have a shortage. It can also indicate that your alternator is failing.
Where is bank 1 sensor 2 on a 98 Nissan Frontier?
Right side after cat converter
Remove Front door panel 98 bravada?
http://www.bodyshopzone.com/archives/trim/door_panels/GMC/Jimmy_1999/front_.html
Do you need a catalytic converter in your 98 jeep?
yes. XXXXXXXXXXXXXXXX It is illegal to remove it. That is Federal law.
Where is the crankshart alignment plug located on the block on a 98 escort zx2 2.0 motor?
Behind the catalytic converter. Take the manifold heat shield off to get a better view of it. I can remove the plug from the bottom of the car with out removing the cat. conv.
How many o2 sensors does an 98 Oldsmobile Bravada have?
normally 2
Will 98 bravada rear end fit under 86 camaro?
Nope
Where is the ecm located for 98 bravada?
The Engine Control Module (ECM) for the 1998 Oldsmobile Bravada is typically located under the dashboard on the driver's side. It can be found mounted to the firewall, just above the brake pedal. To access it, you may need to remove some panels or trim pieces for better visibility and reach.
What happens if you take a catalytic converter off and replace it with replacement pipe on a 98 eagle talon?
Your car will not run correctly and will have no power and use an excess amount of fuel. Besides it is illegal to remove a converter from any vehicle.
How do you replace converter cat on Mitsubishi montero 98?
To replace the catalytic converter on a 1998 Mitsubishi Montero, begin by safely lifting the vehicle and securing it on jack stands. Remove the exhaust pipes connected to the catalytic converter using a wrench or socket set, and detach any hangers or brackets holding it in place. Install the new catalytic converter by reversing the removal process, ensuring all connections are tight and secure. Finally, lower the vehicle and check for any leaks by starting the engine and inspecting the exhaust system.
