Turn it counterclockwise on the vast majority of automobiles. There were some cars in the early days that did have lug nuts that had left handed threads on the left side of the car, but not today. An impact wrench will make quick work of removing lug nuts. Do not use a impact wrench to install the lug nuts. Use a torque wrench and tighten them to the exact specifications listed in your owner's manual. Otherwise you will warp the rotors.
A website named bransport.com carries lug nut removers for various size lug nut locks. It uses a reverse thread that tightens on the lug nut as you turn it counter clockwise to remove.
with the lug wrench!
Remove the plastic lug nut cover with a screwdriver. Use the lug nut key to unlock the one special lug nut per wheel. Usually found in the glove box.
To remove a lug nut from a Land Rover Discovery, first ensure the vehicle is on a flat surface and securely lifted using a jack. Use a lug wrench or socket wrench to turn the lug nut counterclockwise. If the lug nut is stuck, apply penetrating oil and give it time to soak, then try again. Always ensure the correct size socket is used to avoid stripping the nut.
the lug nut adapter is located in the trunk with your jack, spare, and lug wrench, if you have taken it to a shop they may have put the adapter in your glove box, its about twice the size of a lug nut.
To change a flat tire on a 2006 Toyota Matrix with a special lug nut, first, ensure the vehicle is on a flat surface and engage the parking brake. Use the lug nut key to loosen and remove the special lug nut, then lift the vehicle with a jack and remove the flat tire. Replace it with the spare tire, tightening the lug nut securely before lowering the vehicle back to the ground. Finally, double-check that all lug nuts are tightened properly.
It requires a special "key" to remove that nut.
Yes, jack the car up and remove the lug nut to remove the hub cap.
The lug nut size for a 240sx with a four lug pattern is 10x1.25. The lug nut size is 12x1,25
The Honda CR-V lug nut size is a 19 mm lug nut. The 2000-2002 size was a 21mm lug nut.
Put the key in the lug nut lock and keep turning it until the entire locking lug nut cover assembly comes off...just keep turning it clockwise with the key until the whole thing comes off. Then use the lug wrench to remove the lug nut that is holding on the spare tire cover. Remove the cover and then take the other lug nuts off.
I will answer this question based on the many dirt bike tires in which I have changed. When I remove the wheel, there is a nut on one side of the bike which needs to be removed; after removing the nut, the axle will slide out the opposite side of the machine from the nut. I usually refer to this nut as an axle nut rather than a lug nut.