answersLogoWhite

0

depends on the car. GM distributors require removal of the distributor from the engine. Then removal of the drive gear at the bottom of the distributor by driving out the pin.

Remove the shaft through the top of the distributor

Unplug and unscrew the pick up, install new.

Reassemble, preferably with new retaining pin.

Re time engine ignition.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you change pickup coil on a 1988 GMC 2500 pick up?

Remove Distributor,remove drive gear,remove shaft,remove pickup coil.


How do you replace pickup coil gm?

To replace the pickup coil in a GM vehicle, first disconnect the battery and remove the distributor cap for access. Next, carefully remove the retaining screws or clips holding the pickup coil in place, disconnect the wiring harness, and take out the old coil. Install the new pickup coil by reversing the removal process, ensuring it's properly aligned, and reconnect the wiring. Finally, reassemble the distributor cap, reconnect the battery, and test the ignition system.


How do you remove the pickup coil from a 1993 Chevrolet S10 4.3 6-cylinder?

remove the distributor cap remove the screws that attach the pick coil to the base of the distributor and replace in reverse order


How do you change pickup coil on 1978 Chevy pickup?

u have to pull the whole distributer to change the pickup coil


How do you change a pickup destributor?

you must remove the distributor, disassemble unit and replace pick up coil


How do you replace a coil in a 97 Nissan pickup truck?

To replace the ignition coil in a 1997 Nissan pickup truck, first, disconnect the negative battery terminal to ensure safety. Remove the engine cover if necessary, then locate the ignition coil, which is mounted on the engine. Disconnect the electrical connector and remove the bolts securing the coil in place, then carefully pull it out. Install the new coil by reversing the process, ensuring all connections are secure before reconnecting the battery.


How voltage is induced in a permanent magnet pickup coil as the reluctor approaches alignment with the pickup coil.?

The Hall effect.


Where is the 1991 Chevrolet distributor pickup coil?

The pickup coil in a 1991 Chevrolet vehicle is typically located inside the distributor housing. To access it, you'll need to remove the distributor cap and rotor, exposing the coil mounted on the distributor shaft. The pickup coil is responsible for generating a signal that tells the ignition module when to fire the spark plugs. If you're troubleshooting ignition issues, it's important to check this component for proper function.


On an 86 Toyota truck what should the pickup coil resistance be?

Distributor pickup coil resistance 140-180 ohms.


How do you replace the pickup coil on a 1995 Ford Taurus?

remove the distributer, remove the roll pin holding the drive gear onto the distributer shaft, remove the distributer drive gear, remove the shaft from the distributer to gain access to and remove the stator(pick-up coil). Replace the stator, and reassemble everything.


How do you replace the ignition module on a 1976 Chevrolet Cheyenne?

The pickup coil in the distributor? !976 should be an HEI distributor. Take the cap off, unplug the wires going to the distributor, remove the rotor and the pickup coil is under the rotor and held in place with two screws.


How to test pickup coil 1990 chevy pickup?

hey are located inside the distributor and function as the trigger for the ignition system to produce spark. The pickup coil monitors the rotation