You don't. Take it to a shop that does suspension work.
Remove wheel. Remove brake pad retainer pins. Remove old brake pads. Spread caliper pistons apart. Install new brake pads. Insall retainer pins. Install wheel. For more detailed information, please see following links.
To remove king pins, first, lift the vehicle and securely support it on jack stands. Next, remove the wheel and brake components to access the king pin assembly. Use a king pin removal tool or a press to carefully extract the king pin from the axle and steering knuckle. Finally, inspect the components for wear or damage before replacing or reinstalling.
1. Unbolt/remove the wheel 2. Unbolt/remove the caliper 3. Remove/replace the rotor 4. Pull the retainer clips out of the retainer pins on the caliper 5. Remove the retainer pins and let the pads fall 6. Insert the new pads and fix in place with retainer pins 7. Insert the retainer clips 8. Depress the caliper with a c clamp 9. Install the caliper 10. Install the wheel
Remove the two pins going through the pads. Pull out the old pads, push in the piston and install new pads, replace pins with the clips.
The land socket uses lands rather than pins. Because it is easier to install and remove.
Don't remove your rear calipers! Simply drive the 2 push pins out from the outside in and the pads lift out after you remove the retaining spring. The hardest part is driving the pins out..sometimes rusted in pretty good.
The pins of a resistor are interchangeable.
Remove the seat. Remove the battery. Replace the battery. Replace the seat.
To install door pins on a 2001 Bravada, first, ensure the door is fully open. Remove the old pins if necessary by using a punch to drive them out. Align the new pins with the hinge holes, then gently tap them in with a hammer until they are fully seated. Finally, test the door movement to ensure it operates smoothly.
how do i rebuild king pins on front axle of 1974 amrican general postal van
The wires run through the tank to a plug, Dixon ect the plug and remove the pins from it (keeping track of which pin goes where). Most have three pins and an empty slot, if you've got a low fuel warning light in the fairing then you probably have four pins to remove. After removing the pins you simply lift up on the guage it is pressed in with a rubber sleeve. If you must pry on it be smart, use something that won't damage your paint or your chrome.
You replace the truck ...it comes with new hinge pins :((