there is none it,s a hyrdaulic system
Mine does
,
in the rocker cover
remove the center cover on the engine,two cross head screws this will give you access to the leads and plugs
something around 110Nm
10W-40 (per the haynes manual)
The fuel pump reset switch on a Rover 414 is typically located in the trunk area, near the fuel tank. It's often found on the left side, near the rear wheel arch or close to the fuel pump itself. To access it, you may need to remove some interior trim or covers. Always consult the vehicle's manual for specific guidance related to your model.
On a Rover 414, the thermostat is typically located near the engine, often on the engine block or in the coolant housing. It's usually situated along the upper radiator hose, which connects the radiator to the engine. For precise location and access, it's advisable to refer to the vehicle's service manual, as configurations can vary.
To install a front bumper on a Rover 414, first, ensure that the vehicle is parked on a level surface and secured with wheel chocks. Remove the old bumper by unscrewing any bolts or clips that hold it in place, usually found underneath and along the sides. Align the new bumper with the mounting points, then secure it using the appropriate bolts or clips. Finally, double-check all connections and ensure the bumper is firmly attached before lowering the vehicle.
You add it to your water tank this is used to stop oil leaks in engines, follow instructions to the letter or it will not work.
The fuel pump fuse for a Rover 414 is typically located in the fuse box, which is usually found in the engine compartment or under the dashboard on the driver's side. You can identify the fuel pump fuse by referring to the fuse box cover, which usually has a diagram indicating the function of each fuse. If you're unsure, consult the vehicle's owner's manual for specific details related to your model.