you need a 32MM wrench and a hammer or a special tool for the water pump pulley to hold it in place. the threads go the opposite way to remove the fan. with the 32mm wrench on the fan strike the top of it towards the right while pushing on the wrench (to the right) and with a few hard strikes it will come off. then remove the intake tube and the fan shroud. there is a push in clip on the top on the drivers side and a T25 (TORX) ON THE PASS SIDE TOP. REMOVE AND PULL THE FAN SHROUD OUT.
if it is an electric fan please let me know and i will tell you how to remove it.
In order to change the drive belt on 2000 BMW 4 door 323I, you must remove the air filter box, loosen the hose clamp, remove the harness plus, and depress the clip to remove it. Unclip the hose from the air filter box and remove it from the vehicle. Next remove the fan and fan clutch assembly. Next remove the tensioner and remove the belt.
To change the condenser fan on a 1999 BMW 323i, first, disconnect the battery to ensure safety. Remove the front bumper for better access, then unscrew the fan assembly from its mounting points. Disconnect the electrical connector and carefully remove the old fan. Install the new fan by reversing the process, ensuring all connections are secure before reassembling the bumper and reconnecting the battery.
http://wiki.answers.com/Q/How_do_you_remove_the_engine_cooling_fan_assembly_from_a_2000_dodge_intrepid"
remove the fan clutch and fan first
The fan is attached to the fan clutch at the front of the engine. It is held on by one very large nut (I think it's 32mm). Usually you will need to remove the plastic fan shroud first. The difficult part of this is that the nut holding on the fan is a reverse thread, the opposite of what you would expect it to be. You turn it clockwise to loosen. Also, you might need a special tool (Google "BMW fan clutch tool") to hold the fan clutch and keep it from turning when you remove the fan.
silver box on right side of fan shroud. you can disconnect there.
The 2000 Chevy Cavalier cooling fan shroud is held in place with 10 retaining bolts. Remove the retaining bolts and the cooling fan shroud will come off.
Remove your lower passenger side engine mount and you will be able to rock the engine back far enough for the fan to clear the manifold.
If the fan does not stop running after the engine is shut off in the Renault Scenic 2000, there could be a problem with the fan relay switch. The fan relay switch is located in the fuse box.
Does anyone know the proper way to remove the clutching fan on a 2000 Chevy express van 3500 5.7 ltr?
Sawsall.
To remove the engine cooling fan from a 2003 Saturn Ion, first disconnect the negative battery cable to ensure safety. Next, remove the front grille and the radiator shroud to access the fan assembly. Disconnect the electrical connector from the fan, then unbolt the fan from its mounting points and carefully pull it out from the engine compartment. Finally, reverse the steps to install a new fan if needed.