Remove the wiring harness from the back of your 1996 Chevrolet blower motor. Remove the blower motor retaining bolts. Remove the fan from the blower motor. Reverse the process to install your new blower motor.
what you only need to replace is the blower motor speed controller or also kown as a blower motor resistor.
To replace the blower motor on a 1996 Chevy Corsica, first disconnect the negative battery terminal. Then, remove the dashboard trim and the screws securing the blower motor cover, which is located under the passenger side of the dashboard. Disconnect the electrical connector and unscrew the blower motor from its housing. Install the new blower motor by reversing the steps, ensuring all connections are secure before reassembling the dashboard.
The blower motor on a 96 Accord is behind the glovebox. You need to remove the door to the glovebox and the glovebox frame from the dashboard to get to the motor.
You have power but make sure that you also have a good ground and if so then you will need to check both the blower resister as well as the blower switch..........
Could be, Blown fuse, Bad blower motor, Bad blower motor speed resistor, Bad blower switch,
replace your heater core and blower motor if nothing works at all. also don't forget to drain your old water and antifreeze and replace with fresh antifreeze
To replace the AC blower in a 1996 Infiniti I30, start by disconnecting the negative battery terminal to ensure safety. Remove the dashboard panel or lower cover to access the blower motor, typically located under the passenger side. Unscrew the blower motor and disconnect the electrical connector, then install the new blower by reversing the steps. Finally, reattach the dashboard panel, reconnect the battery, and test the new blower for proper operation.
Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.
On the fire wall. Behind the engine.
Blower motor resistor is bad. It is a little circuit board with resistors on it that changes voltage to the blower motor. When it goes bad, you get full speed only.
On the inside of the firewall, below and behind the glove box.