0
To replace the blower motor on a 2000 Chevy S-10, first disconnect the negative battery cable. Remove the passenger side lower dashboard panel to access the blower motor, then disconnect the electrical connector and remove the screws securing the motor. Replace it with the new blower motor, reattach the screws, reconnect the electrical connector, and finally, reinstall the dashboard panel before reconnecting the battery. Test the blower motor to ensure it operates correctly.
What else can I help you with?
Repair squeaking blower motor 2000 Chevy s10?
No repairing those blower motors, replace it with a new one.
How do you replace Chevy S-10 blower motor?
Need to know the model year Chevy S10.
How do you fix blower resistor on 2000 Chevy blazer s10?
Ain't no fixin it, you have to replace it with a new one.
Where is the Blower motor resistor on a 2003 Chevy S10 pickup?
Under the hood, passenger side firewall, not far from the blower motor.
What is wrong with your 1997 s10 if the blower motor will not work?
If you have no blower speeds at all check the fuse, then check the blower motor switch and electrical plug for a melt down situation, then check the blower motor itself.
Why does heater blower on 1992 s10 run on high only?
Probably the blower motor resistor is shot.
Where is the blower motor relay on an 89 s10 blazer?
The blower motor high speed relay is located under the hood, on the passenger side firewall close to the blower motor. The blower motor speed resistor is also located in that same area.
How do you fix the AC blower on a 1989 Chevy s10 pickup?
Check to see if it is getting power - if so replace motor - if not check fuse, relays and switch
Where is blower motor resistor on a 1993 2.8L 5-speed S10?
Should be under the hood, on the firewall, passenger side, not far from the blower motor.
How do you replace the blower motor resistor on an s-10 blazer?
You didn't say what year but my 2002 S10 Blazer has the HVAC blower motor resistor located under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire harness and remove the two small screws holding it in place and gently pull it out.
How do you replace 1997 s10 blower motor resistor?
Locate the resistor under the hood near the blower motor on passenger side firewall. Unplug the electrical connector. Remove the screws holding the resistor in place. Remove the resistor. Install in reverse order.
How do you change a blower motor resistor for a 2000 Chevy S10?
First locate the resistor, it is under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire connection and remove the three small screws holding it in place, then remove the resistor.
