To replace the heater blend door on the passenger side of a 2010 Ford Explorer Sport Trac, first disconnect the vehicle's battery to ensure safety. Then, remove the dashboard and the passenger side HVAC housing, which may require taking out various screws and clips. Once you access the blend door assembly, replace the faulty blend door with a new one, and reassemble the HVAC housing and dashboard components in reverse order. Finally, reconnect the battery and test the heating system to ensure proper functionality.
Under the dash board on the passenger side. You can find it easily by looking for two hoses (under the hood) that connect to the heater core right at the firewall.
after you take the two screws out of bottom of door panel does it pop off or how do you get it off?
Bank 1 is the passenger side of the engine in your Ford Explorer
On the passenger side of the engine
No, you cannot replace a faulty Ford Sport Trac cluster with a cluster from the 2005 Explorer.
The passenger side of the engine
I just bought my heater core for my 1997 Ford Explorer 4x4 Sport for $60.00(Plus Tax) but I was surfing the web and found that you can order it in line with SPI or STANT from $29.00 to 32.00 plus shipping. Good Luck
Bank 1 is the passenger side of the engine in your Ford Explorer
On top of the accumulator/drier (It's the cylinder on the passenger side of the engine not too far from your heater fan) It has a plastic cap covering the valve.
In the passenger footwell , by ( or behind ) the kick panel
I goes under the passenger side back seat.
Bank # 1 is the passenger side of the engine