All of the shift linkage should be internal. You will have to remove transmission, split the transmission in two to access the linkage.
Replace shift linkage Replace shift linkage
To fix the shift gear on a 1995 Nissan King Cab, start by inspecting the shift linkage for any signs of wear or damage. If the linkage is fine, check the transmission fluid level and condition, as low or dirty fluid can affect shifting. If necessary, adjust the shift linkage according to the service manual specifications or replace any faulty components. If the issue persists, consult a professional mechanic for further diagnosis and repair.
The 2001 Chevy Cavalier automatic transmission shift linkage is held in place with a swivel nut on each end of the shift linkage. Turn the swivel nuts to the left and the shifting linkage will come off. Reverse the process to install your new shift linkage.
If it's an automatic transmission, it is attached to the transmission where the shift linkage is attached.
To replace a manual shift linkage seal, first, ensure the vehicle is on a level surface and secure it with jack stands. Remove the shift linkage from the transmission, typically by unbolting or disconnecting any retaining clips. Then, carefully pull out the old seal from its housing and clean the area before installing the new seal, ensuring it sits flush. Reassemble the shift linkage and test for proper operation before taking the vehicle for a drive.
http://www.dmctalk.com/showthread.php?t=8699
The switch is located on the driver side of the transmission. right where the shift linkage joins the tranny.
Your linkage is getting locked up. Look at your transfer case, you should see it. The majority of the time once you see were the linkage is you can mess with it and free it.
How do u replace the front axel on a 1997 nissan altima
Your question is too vague. Purchase a service repair manual.
To replace the shift linkage on a 1999 Ford Taurus, start by safely lifting the vehicle and securing it on jack stands. Remove the shift cable from the transmission and the shifter assembly inside the vehicle, which may require removing the center console for access. Install the new shift linkage by attaching it to the transmission and reassembling the shifter assembly. Finally, ensure everything is properly aligned and test the shifting mechanism before lowering the vehicle.
To replace the gear shift linkage in a 1997 Ford Ranger, first, disconnect the battery to ensure safety. Then, locate the shift linkage under the vehicle, typically connected to the transmission and the shifter mechanism. Remove any retaining clips or bolts holding the linkage in place, and carefully detach it. Install the new linkage by reversing the removal steps, ensuring all connections are secure before reconnecting the battery and testing the shifter.