0
I am not 100% sure this will work on a tC, but i have an xA and this trick works on almost ALL Toyota's made after 2000
insert key, and turn to "ON" position.
Look at odometer, make sure its on ODO and not TRIP1, or TRIP2
turn the key to the "OFF" position.
press and hold the trip reset button (the only button on the odometer)
while holding, turn key to "ON" position again.
The odometer will show blinking bars, succeeding from right to left. once all bars have succeeded, it will say "000000000"
Your MIL has been rset.
Turn your key to "OFF" position, then back, and start your car.
The MIL light should be off.
(NOTE: this does not reset the CEL, just the MIL. the CEL or Check Engine Light cannot be reset without using an OBDII interface, or a hard reset by removing the battery cable. This technique should only be used when preforming a full service, or an oil change.)
What else can I help you with?
How do you Reset Scion airbag light?
how do i reset srs light on scion tc
How do you reset the maintenance required light on a 2010 Scion XD?
You will find that info in the owners manual.
How do you reset airbag light?
how do i reset srs light on scion tc
How do you reset the maintance required light in a Scion tc?
To reset the maintenance required light in a Scion TC, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then back on; the maintenance light should be reset. If it remains lit, repeat the process to ensure it was done correctly.
How do you reset maint req light on a 2009 Scion TC?
To reset the maintenance required light on a 2009 Scion TC, turn the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, the maintenance light should turn off. If it does not reset, repeat the process.
How do you reset maint reqd light on 2010 scion Xb?
To reset the maintenance required light on a 2010 Scion xB, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After releasing the pedal, the maintenance light should turn off. If it doesn't reset, repeat the process.
How do you reset the airbag light in the 2008 Scion xD and why is it on?
You have a defective airbag. You replace that bag.
How do you reset the change engine oil light on a 2006 Scion XB?
change the oil
How do you reset the maintaince required light on a scion xb 2009 model?
With the key "off", push and hold the odometer reset button. With your other hand, turn the key to the "On" position. The odometer will count down dashes(-) and then display 000000. Let go of the odometer reset button. Turn key off and then on and start the engine. "Maint. Required" light should stay off
How do you reset the service light in a 2008 scion xd?
To reset the service light in a 2008 Scion xD, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine to ensure the service light has been reset successfully. If the light remains on, repeat the process.
How do you reset maintenance required light in a 2008 Scion XB?
1. Set your ODO to Trip A 2. Turn off ignition 3. Hold ODO button 4. Turn on ignition 5. Hold ODO button until Maintenance Required light stops flashing
How do you reset the Maintenance Required light on a 2005 Scion xa?
t's not a problem, it is merely a reminder light so customers will be prompted to do the required maintenance. Turn the ignition ON Make sure the "ODO" is displayed, not "TRIP" Press and hold the TRIP reset button Turn the key off and back on Hold the reset button until the lines on the ODO display disappear and the ODOMETER reading comes back. answered by Liselle
