0
What else can I help you with?
How do you reset the airbag light in the 2008 Scion xD and why is it on?
You have a defective airbag. You replace that bag.
How do you reset the service light in a 2008 scion xd?
To reset the service light in a 2008 Scion xD, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine to ensure the service light has been reset successfully. If the light remains on, repeat the process.
How do you reset the Malfunction Indicator Light on a 2008 caravan?
normally disconnecting one of your battery terminals and reconnecting it will reset the trouble light.
How do you turn off the maintenance light on a 2008 Camry?
Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.
How do you reset engine light on 2008 vw eos?
To reset the engine light on a 2008 VW Eos, first, use an OBD-II scanner to read and clear any diagnostic trouble codes (DTCs) that triggered the light. If you don't have a scanner, you can disconnect the battery for about 15 minutes to reset the system. After reconnecting the battery, check if the light remains off. If the light returns, it may indicate an underlying issue that needs to be addressed.
How do you reset 2008 Honda Element service light?
How do you reset 2008 honda element service light?
How do you reset engine light in 2008 buick lucerne?
how do you reset check engine light in 2008 buick lucerne
How do reset t-belt light cruiser 2008?
Hi I have cruiser 2008 gxr how is reset t.belt light
How do you Reset Maintenance Warning Light on a 2008 Toyota 4Runner?
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
How do you reset oil change light on 2008 Crown Victoria?
take off the groud from the battery,wait for few minus then put it back
How do you reset the codes on a 2008 Saturn Vue?
To reset the codes on a 2008 Saturn Vue, you'll need to disconnect the vehicle's battery. Start by turning off the ignition and removing the negative battery cable; leave it disconnected for about 15 minutes. This will clear the codes from the car’s computer. Reconnect the battery, and the codes should be reset. If the check engine light reappears, further diagnostics may be necessary.
How do you reset t belt light on Toyota hilux diesel 2008?
There are a couple of ways to reset the timing belt light on a 2008 Toyota Hilux diesel. One way is to unplug the battery for up to five minutes and see if that will reset the light. If not, you can hold the trip meter button down and turn the key, but not start the vehicle. This will reset the light most of the time.
