Easy. With key in ignition and car off, press the odometer reset button into full down position. Turn key to position just before full start and continue holding the button until the light goes off and internal maintenance mileage counter light resets.
Note the light begins to blink on start up as the maintenance counter nears the schedule before it stays "on" continuously awaiting a reset. This procedure is detailed in the tc manual.
You will find that info in the owners manual.
To reset the maintenance required light in a Scion TC, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then back on; the maintenance light should be reset. If it remains lit, repeat the process to ensure it was done correctly.
To reset the maintenance required light on a 2009 Scion TC, turn the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, the maintenance light should turn off. If it does not reset, repeat the process.
To reset the maintenance required light on a 2010 Scion xB, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After releasing the pedal, the maintenance light should turn off. If it doesn't reset, repeat the process.
how do i reset srs light on scion tc
1. Set your ODO to Trip A 2. Turn off ignition 3. Hold ODO button 4. Turn on ignition 5. Hold ODO button until Maintenance Required light stops flashing
maintenance with engine
t's not a problem, it is merely a reminder light so customers will be prompted to do the required maintenance. Turn the ignition ON Make sure the "ODO" is displayed, not "TRIP" Press and hold the TRIP reset button Turn the key off and back on Hold the reset button until the lines on the ODO display disappear and the ODOMETER reading comes back. answered by Liselle
how do i reset srs light on scion tc
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
aperantly take the light out
The maintenance required light requires a scan tool to be reset.