answersLogoWhite

0

What else can I help you with?

Related Questions

The car will not start and the horn honks and lights flash; how do you reset?

wait 10 minutes for the passlock system to reset for a GM vehicle.


How to reset the passlock on 1998 Chevy 1500?

cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire. but will it start iwas told that it wouldnt


Is there a fuel pump reset switch for a 1992 Chevy blazer s 10?

No. A Chevy Blazer does not have a reset switch.


How do you reset passlock 2004 chev Colorado?

To reset the Passlock system on a 2004 Chevy Colorado, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. After that, turn the key to the "Off" position for a few seconds, then start the engine. If done correctly, the Passlock system should be reset, allowing the vehicle to start normally.


How do you reset passlock on a 2003 chevy impala?

To reset the Passlock system on a 2003 Chevy Impala, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave the key in this position for about 10 minutes until the security light turns off. Then, turn the key to the "Off" position for a few seconds and repeat the process two more times. After the third cycle, the Passlock system should reset, allowing you to start the engine.


Does a 2000 blazer have a fuel pump reset?

sorry. No Reset on those.


How do you reset the security light in your 2001 Oldsmobile Alero?

== == The repair below is a theft password relearn procedure. It may get your car to start for a while, but does not repair the problem. The most common cause for this problem is the PASSLOCK ignition cylinder. It may need to be replace, then re-learned again.- TechJK -------------------------------------- Turn the key to the on position for about 30mins. After the first 10 minutes the security light starts to blink. Then it turns solid again after another 10 minutes. The last 10 minutes is to reset the passlock system (you can leave it on for longer to make sure you reset it). Now take the key out and try to start the car. I had to do this when my car was not starting; the fuel pump was off because of my passlock system.


Where is the fuel pump reset button located on a 1998 Chevy Blazer S-10?

The Chevrolet Blazer does not have a fuel pump reset button.


How do you reset check engine light for the 2009 Chevy trail blazer?

How do you reset check engine light for the 2009 Chevy trail blazer?


How do you reset fuel pump on 2001 Chevy blazer?

Chevrolet does not have reset switches.


How do you reset passlock on 2001 Saturn?

Turn the engine two seconds then leave the key in the run position for exactly ten minutes...the anti-theft security light should go from blinking to solid at the ten minute mark. Immediatly run the engine and the Passlock is reset. Good Luck!!


Where is the reset switch for a 1999 blazer?

There is none.