0
What else can I help you with?
How do you disable seat belt warning chime in a corsa?
plug the seatbelt in.. the warning stops then ;-)
How do you turn off the seat belt warning chime on a 2007 odyssey?
Put on your seatbelt!
How do you diable seat belt warning chime in Honda CR-V?
You can disable the seatbelt warning chime, in your Honda CRV, by removing the fuse. The fuse can be found in the fuse box in the engine compartment.
How do you stop the dinging sound when a warning occurs door seatbelt etc?
Find and remove or disconnect the chime relay.
Why does your 2006 Sonata chime four times about every fifteen minutes for no apparent reason?
This may be the seatbelt disconnect warning. If you do have the seatbelt properly connected then the sensor may be bad.
If the warning chime for seatbelt works on an Olds Delta 88 but the ignition and headlights on chime does not are they separate chimes?
they are two separate fuses. so two separate chimes. look at your fuse box.
2009 Camry seatbelt chime?
yes.
How do you disable seatbelt chime on Honda pilot?
To disable the seatbelt chime on a Honda Pilot, start the vehicle and ensure the driver's seatbelt is unbuckled. Turn the ignition to the "ON" position without starting the engine, then buckle and unbuckle the seatbelt three times within 10 seconds. After that, turn the ignition off. When you start the vehicle again, the seatbelt chime should be disabled.
Does passenger seat chimes on Acura MDX 2005 when no seatbelt on?
Yes, the 2005 Acura MDX is equipped with a warning chime that activates when the passenger seat is unbuckled while the vehicle is in motion. This safety feature is designed to remind passengers to fasten their seatbelts. The chime will continue until the seatbelt is secured or the vehicle is turned off.
How do you turn off the seatbelt alarm on a 2000 Toyota Tundra?
Well you should always wear a seatbelt but you can turn off the chime by simply grounding the wire lead at the seatbelt causing the electricity to flow through and the chime to turn off
How do you make your seat belt chime stop on your 2008 dodge ram?
To turn off the seatbelt chime in 2006-2008 Dodge Rams and some other newer Dodge vehicles, follow this procedure: Get in the vehicle, close the door, put on your seatbelt. Start the engine, wait for the seatbelt light to turn off. Within 30 seconds of the light turning off, unbuckle and re-buckle the seatbelt 4 times, making sure the seatbelt light responds (turns on and off) each time you unbuckle and re-buckle the belt. Ending with the seatbelt BUCKLED, turn off your engine. If done correctly, you will immediately hear one chime to verify the programming. To re-enable the chime, simply repeat this procedure. NOTE: Although the seatbelt chime will not chime constantly if your belt is not buckled while driving, it WILL still chime when you first start your engine, and the seatbelt light will stay on to remind you. The light can be deactivated also, but it is a much more complicated (and I feel unnecessary) procedure. WARNING!!!: DO NOT deactivate the seatbelt chime by cutting or splicing the wires to the seatbelt buckle under the seat. THIS WILL DISABLE YOUR AIRBAGS even if your belt is buckled!!! AIRBAGS are DEADLY if your belt is not buckled, so there is a sensor in the buckle which disables the airbags when the belt is not buckled. If you cut or splice these wires, you also disable that sensor. Turning off the chime using the programming option keeps your airbags working properly. Hope this helps, ENJOY YOUR DODGE!!! -Mike Vidal, Forked River, NJ
How do you turn off the seatbelt chime on a 2006 Acura RSX using the dash computer interface?
buckle your seatbelt
