0
in the car engine block there are cylinders. in each cylinder theres a pistion. a piston works by exsplosion in the cylinder. that exsplosion comes from the spark plug. then there gas. when the carb puts the air and fuel mixture in the spark plug goes off and it pushes the piston down. then there are valves there are 4 valves on each cylinger. 2 valves are exhust and 2 are the intake valves. the air and fuel mixture come threw the intake and when the air go off there is smoke and the exhust valves open then the smoke goes threw the manafolds and out the tailpipe.
What else can I help you with?
What team did Bob Lanier play for in the NBA?
Detroit pistion
Why am I losing compression in cylinder 283 Chevy?
Bad are burnt intake or exhaust valve. Pistion rings broken, Burned pistion. Blown head gasket. That is all that would cause no compression are a loss of compression.
How do you stop blowby on a 55 rocket?
Blow by is caused from the compression rings on the pistion being broken are just worn out. Must tear engine down and replace all of the pistion rings.Nother words engine needs REBUILT.
What is the torque spesifications of the main bearing cup pistion bearing cups and the cylinder head bolts of a 1kz 3 liter engine in a landcruser?
what is the torque specifications of the main bearing cup pistion bearing cup and cylinder head bolt tighteness
Does it matter if the piston front mark is pointing to the rear of the engine on a 1985 350?
If the notch on the top of the pistion is pointing to the rear, Then the pistion is installed wrong. If you keep puting the pistions in you will come to one that will no fit on the crankshaft. All notches MUST point to the front.
Can pistns be removed and put back on a small block Chevy?
Yes, But they have to be put back in the SAME hole/cylinder they came out of. And if you look at the top of the pistion you will see a slot cut in the top of the pistion on one side. That slot points toward the front of the engine.
Where is the number one pistion on a 4.3L truck?
Drivers side, first one up front.
Which way should pistons point with grooves on btm towards front?
If you look at the top of the pistion you will see a small grove are slot that is right on the edge of the top of the pistion and it is only on one side. That mark,groove,slash,arrow are even a dot means that it points to the front of the engine.
How to fix a collapsing caliper on a 1993 New Yorker?
replace it or release hose pressure push back pistion
Can any car alarm work on any car?
no any car does not work on any car
How do you change crankshaft position sensor?
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
How hard would it be to turbo charge a 1993 eagle talon es?
i wouldn't bother just get a turbo 4g63. the compression is higher on the non turbo 4g63. and the turbo 4g63 has oil squiters to cool the pistion and cylinders. you will spend as much money putting a turbo on your car as the difference would be selling your car and buying a 1g tsi awd
