The cost to replace a Ford GEM (Generic Electronic Module) can vary widely depending on the model and year of the vehicle, as well as labor costs in your area. On average, you might expect to pay between $200 and $600 for the part itself, with additional labor costs ranging from $100 to $200. Overall, the total replacement cost could be between $300 and $800. It's advisable to get a quote from a certified mechanic for a more accurate estimate.
The Gem Module is a relay that control the majority of the electrical functions in late model ford vehicles
The GEM is $1200.00 plus labor. Better ideas by Ford
The GEM in a ford windstar is located up inside the dash, above and to the left of the gas pedal. it's held in with a single bolt.
where is the gem module located on a 2002 ford f 250
To replace the GEM (Generic Electronic Module) on a 1998 Ford Windstar, start by disconnecting the negative battery cable to ensure safety. Remove the trim panel to access the GEM, which is typically located above the driver's side kick panel. Disconnect the wiring harness from the GEM and unbolt it from its mounting location. Install the new GEM by reversing these steps, ensuring all connections are secure before reconnecting the battery.
The gem module on an 03 Ford Explorer is under the dash. It is just to the left of the radio.
Generic Electronic Module
To replace the GEM (Generic Electronic Module) on a 2001 Ford Expedition, first disconnect the battery to ensure safety. Locate the GEM, which is typically found under the dashboard on the driver's side, near the fuse box. Carefully remove any screws or clips securing the module, disconnect the wiring harness, and then install the new GEM by reversing the removal process. Finally, reconnect the battery and check for proper functionality.
in the fuse panel under dash
To replace the GEM (Generic Electronic Module) in a Ford Sport Trac, first disconnect the vehicle's battery to ensure safety. Locate the GEM, typically found under the dashboard or behind the fuse panel, and remove any necessary panels to access it. Disconnect the wiring harness from the GEM and unbolt it from its mounting location. Install the new GEM by reversing the process, reconnecting the wiring, securing it in place, and finally reconnecting the battery.
I believe the GEM is in the center stack of the dash and that the radio has to be removed to gain access
You can find the module for your 2000 Ford Explorer on the firewall in the engine compartment. The module will be on the drivers side of the firewall.