0
Peugeot 806 hdi keeps cutting out and the engine management light comes onbut then the engine starts again when you turn the ignition on please help?
This happened to me on my 806 and the answer was to remove the fuel tank, remove the fuel pump from the tank and remove any debris found in and around the pump suction - there is only a small inlet port on the pump so any debris eventually ends up there and blocks the suction for the pump.Since doing that I've not had the thing stop suddenly with little warning in the middle of the road! HTH
What else can I help you with?
Where is the engine management and ignition sensor on 2003 Nissan altima?
There are dozens of sensor that have to do with engine management and ignition all over the engine.There are dozens of sensor that have to do with engine management and ignition all over the engine.
What is the ignition timing on a Peugeot 206?
show me photo of timing engine peugeot 206 rc
Where is the engine management and ignition sensor on a 1999 Plymouth Neon?
Where is the engine management and ignition sensor on a 1999 plymouth voyager?
Where is the ignition module on a Peugeot 106?
The ignition module for a peugeot 106 is in the engine compartment. Facing the car with the hood open, the ECU is behind the headlamp nearest your left hand.
Engine turns over but will not start after fitting ignition barrel on peugeot 107?
six
How do you install a duralast engine management and ignition in a 1990 gmc serria 1500?
where is a Duralast engine management and ignition part number SW2083 located
How do you install a duralast engine management ignition in a 2003 Chevrolet suburban 1500?
can you sholme the diagram how to installl a duralast engine management ignition in a 20003 chevrolet suburban
What are the technical data of the engine and the maximum speed of the peugeot 305 GL 1978?
The technical data of the engine of the 1978 Peugeot 305 GL includes a spark ignition 4-stroke engine and 59 hp. Its maximum speed is 144 km/h.
What is ignition coil fault on peugeot 206?
An ignition coil fault on a Peugeot 206 typically refers to a malfunctioning ignition coil, which is responsible for transforming the battery's low voltage into the high voltage needed to ignite the fuel-air mixture in the engine's cylinders. Symptoms of a faulty ignition coil may include engine misfires, rough idling, reduced power, and increased fuel consumption. This issue can lead to poor engine performance and may trigger the check engine light. Diagnosing and replacing the faulty ignition coil often resolves these problems.
Does a peugeot 406 2.0 hdi have a limp home fuction when engine management light comes on?
Yes it has.
Where is the ignition timing aperture on a peugeot 205 gti 1.9?
On a Peugeot 205 GTI 1.9, the ignition timing aperture is located on the engine block near the flywheel. Specifically, it can be found on the left-hand side of the engine, typically near the distributor. To check the ignition timing, you will need to connect a timing light to the appropriate wire and observe the timing marks on the crankshaft pulley.
Where is the Peugeot 106 ignition timing sensor?
The ignition timing sensor on a Peugeot 106 is typically located near the engine's flywheel or crankshaft, often mounted on the engine block. It may be positioned on the side of the engine, close to the timing belt or chain area. To access it, you may need to remove certain engine components, so consulting the vehicle's service manual for specific guidance is recommended.
