six
To remove the ignition barrel from a 2002 Peugeot 406 HDI estate, first, disconnect the vehicle's battery to ensure safety. Next, remove the steering column covers by unscrewing the screws securing them in place. Insert the key into the ignition and turn it to the "on" position to unlock the barrel; then, locate the release tab or pin on the side of the ignition assembly and press it while pulling out the ignition barrel. Carefully disconnect any wiring harnesses attached to the barrel before fully removing it.
To change the ignition barrel on a Peugeot 406, first, disconnect the car battery to ensure safety. Remove the steering column covers by taking out the screws and carefully prying them apart. Then, insert the key into the ignition, turn it to the "ON" position, and press the release pin on the barrel to pull it out. Finally, install the new barrel by reversing the process, ensuring it locks into place securely before reassembling the steering column.
May require a new ignition barrel. The 106 is known for problems with the ignition barrel. Looking at a bill of �60 - �200 depending on where you go and the type of immobilizer used on the car.
The cost of a new ignition barrel and keys for a Peugeot 206 can vary based on factors like location, dealership pricing, and whether you choose an OEM or aftermarket part. On average, you might expect to pay between £100 to £300, including parts and labor if installed by a professional. It's advisable to get quotes from local dealerships or automotive locksmiths for a more accurate estimate.
The ignition barrel can be removed by removing the retaining ring. The barrel will slide out. Remove the wiring harness from the back of the barrel.
the key needs to be in the barrel and turned until the two small square pegs on the underside of the barrel casing can be pushed into the barrel .allowing the barrel to be pulled out i just did this on my farthers car and i believe there should be two screws securing the barrel aswell but they were missing hope this is of help to you
The ignition timing for a 1970 Ford Mustang with 302 - V8 - 2 barrel carburetor is : ( 6 degrees BTDC )
to remove stilo ignition barrel, look underneath the barrel. there is a square button holding the barrel in. put the key in the ignition, turn 2 notches, and press the button in with a screwdriver. Then wiggle the barrel out using the key.
The instructions to replace the ignition barrel boot release and door locks on a Perugeot 106 Zest 2 can be found online by doing a web search. If you have issues doing so after researching the instructions, I recommend calling a mechanic or locksmith to assist you.
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
Sounds like you are loesing the live for the radio when the engine is running cheak the ignition barrel is ok Just an idea Oliver
you need to have the ignition barrel in the on position otherwise you cant to it.