0
The HOLD light indicates the driver has selected NOT to allow the car to shift into a higher gear (i.e., 5th gear -also called Overdrive). It is mostly used when driving uphill when the driver wants to prevent the car from shifting into a gear that is too high and possibly could cause the engine to lug (over-strain).
What else can I help you with?
How do you reset the service light on a 1995 Volvo 960?
remove the rubber plug on the instrument panel (front of speedometer)Insert a small pin and hold for a few seconds, all done
How do i extinguish the Maintenance light on a 2001 accord?
# Turn off the engine. # Press and hold the select/reset button in the instrument panel, then turn the ignition switch ON (II) # Hold the buttons for about tenseconds, until the indicator resets. John
How do you reset the maintenance required light on a 2004 element?
On my 2005 Element it goes like this. Turn off engine. Press and hold the Select/Reset button on the instrument panel, then turn the ignition switch to on. Hold the button for about 10 seconds until the indicator light goes out.
What does it mean when the hold light flashes on youir Mazda Familia 1997 model?
It can mean several things if the hold light flashes on your Mazda Familia 1997 model. It can indicate a shortage in the wiring or a blown fuse.
What does the hold light mean on a 1990 Mazda protege mean?
The HOLD light means you have an electrical problem with your transmission. See your mechanic ASAP.
What controls the hold light is on your 2000 Mazda millenia s?
Button on the shifter.
What does a blinking Hold Light on a 1992 Mazda Protege mean?
tranny problems
When does the maintenance light turn on?
About 1000Km (500M) before your scheduled maintenance. You can turn it off if it bothers you. 1. Turn off engine. 2. Press n hold the select/reset button in the instrument panel. 3. Hold the button for about 10+ sec, there you have it.
How do your reset the maintenance required light on 2007 Honda element?
Turn off the engine. Press and hold the select/reset button in the instrument panel, then turn the ignition switch ON (II). Hold the button until the indicator resets (approximately ten seconds).
How do you replace the instrument light bulb on 1996 Honda Civic EX?
You have to pull the instrument panel to change any instrument bulb, but the panel comes out pretty easy. 1. Adjust the steering wheel as low as possible to keep it out of the way. 2 Unscrew the two screws at the top of the instrument panel bezel. 3 Pull the bezel straight out, It has a couple of lower clips, but they will pop out. 4. Unscrew the 4 screws that hold the instrument panel in place, 2 on lower edge and 2 on upper edge. 5. Pull the Instrument panel cluster straight out, carefully. As you get it out a bit you can reach the several ribbon connectors in the back, mine has 3. Disconnect those connectors and the panel lifts out. 6. The bulbs are in the back, and there are lots of them, one for each warning light, etc. Pull the bulbs and check them, or maybe you already know what's lighting up and what isn't. Replace bad bulbs. 7. Reassemble in opposite order.
How do you take off the instrument panel or dashboard for a 97 Monte Carlo?
Hold firmly and pull. It has slide clips.
What does it mean when the hold light starts flashing on a 1994 Mazda mpv?
The hold light is a warning indicator. Essentially, the flashing indicates that there is an electrical problem with the transmission.
