The AC clutch relay on a 1989 Dodge Ram is typically a small rectangular or square plastic component, often black or gray in color. It will have several terminals for electrical connections, usually mounted in the engine bay fuse box or on a relay panel. The relay may have a label or diagram indicating its function, which helps in identifying it among other relays. Always refer to the vehicle’s service manual for precise identification and location.
That sounds like a sticking clutch relay.
That sounds like a worn clutch.
The clutch is the part of the compressor which is not turning when the A/C button is not pressed on...The clutch is part of the compressor. The relay is located in the fuse box close to the battery / on the cover of box is printed something like M/G/ CLT. The relay part number should be 90987-022028
it sounds like ur clutch went out in it.
On top of the starter - looks like a juice can
Jumped directly from the relay? Bad compressor clutch, bad relay, low or excess refrigerant.
The 1989 Honda accord fuel pump relay switch is contained in a square metal box. The switch will have two wires going to it. The switch should be labeled.
There's a clutch on the starter that acts like a Bendix gear on a car. This clutch is stripped out on your bike. You'll need to pull the starter to replace it.
I believe on that model there is only a relay; no reset like some older Fords have. Mark
if your turning signal is not working it maybe the turn signal. it was like that in my 93
Have a 1989 Honda accord with carburetor, My problem is will not run, Put gas in carburetor and it will run, Changed the fuel pump still no go, From my Research sound like fuel pump relay, What I need to know is the fuel pump main relay and the fuel cutoff relay the same thing? Thanks in advance for any help. Sound like your fuel pump relay is not working. Did you check your fuses? Fuel pump relay and fuel pump cut off are NOT the same thing. If you replaced the fuel pump is more like your fuel pump RELAY is bad. QUESTION. did you replaced the 2 filters on you gas line?? maybe you have a plugged filter. hope this help you some.
If the clutch switch failed then the car will not start unless the switch is bypassed. The purpose of a clutch safety switch is to prevent the car from dangerously starting, so when it malfunctions that car will not start without it switch off.