Well it means your battery is going to be discharged in short order. Most of the time the light stays on because you have it turned on. Make sure that is not the case. If it is in the off position and still stays on, then the door switch is probably defective. Common problem with the Jeep.
Flasher stuck in closed position defective switch
probably a faulty or mis-aligned brake light switch.
The switch is probably bad or you aren't turning the knob all the way off.
i dont know you should just get a new vehical
Probable broken wire in the harness in the drivers door jamb.
take the battery off and then fix the light swish
The ABS and Brake lights stay on when the Abs computer has detected a malfunction and set a trouble code. You need to have the system checked for codes
The trailer plug in the Jeep may be wired wrong. Make sure the tail light plug is connected to the jeep taillight circuit. Some trailer plugs include a "hot" wire that allows the trailer to run a few accessories. Your trailer tail lights may be connected to that circuit.
check and make sure all the lights are on like if a turn signal is out in the front then the signal will stay on in the back when you turn the turn signal on.
The closest answer to your question is the equator.
what are the warning lights in the Chevy cavalier z24. and what do they mean
There is a dashboard illumination switch that controls the brightness. If it is pushed up fully, the interior lights will stay on. Lower the switch slightly until the interior lights go off. When doors are closed, if the switch is lowered, the lights should go off after about 30 seconds max, maybe less. Hope this Helps, it did on mine.