0
What else can I help you with?
Subaru check engine code 12?
It is possible that a Subaru Check Engine Code #12 is a bad starter switch. This is usually the starter relay switch malfunction code for Subaru.
Does the 1988 subaru gl wagon have a check engine light?
yes
96 Subaru legacy Brighton the check engine light comes on it will turn over bt wil not start?
Check this site for information: http://www.troublecodes.net/Subaru/
How do you reset the check engine light on a 2000 Subaru Forester?
With the proper scan tool.
Will check engine light come on with a bad knock sensor on a 1998 Subaru Forester?
Not necessarily.
What does Check engine light mean for a Subaru 1996?
If you take your subaru to Parts plus or an automotive store you can usually have them hook up their computer to the side panel, in the dash board of your car and it will give them a code. The code will tell you exactly why the check engine light is on.
What does 'ecs' stand for on a Subaru?
Electronic Controlled Suspension. That's a nice thought, but, I'm pretty sure this is Subaru's version of the 'Check Engine' light. Electronic Stability Control
Where is the transmission dipstick located on a 2002 Subaru Legacy Outback?
*Hopefully* the same as other Subaru engines, low down the left hand side about half way up the engine (facing the engine) there should be a short yellow loop. Check it when the engine is cold!
How do you reset the check engine light on 1993 Subaru Justy?
After repairing the cause of the code, you can clear it with a scan tool.
How do you reset check engine light on subaru?
take earth of batt for 5 mins an then put it back on an it resets it
How do you check the transmission fluid level on subaru forester?
I want to check the level of atf temp in my subaru forester 2010. On checking the transmission fluid level, after the car was driven about 10 km and was put in each gear and setting the select level in the "p", do i have to turn off the engine or idle the engine before i check the atf level?
How do you reset the service light in a Subaru Forester?
To reset the service light in a Subaru Forester, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. Afterward, turn the ignition off and then start the engine to check if the service light has been reset. If it remains on, you may need to repeat the process or consult your owner's manual for specific instructions based on your model year.
