0
What else can I help you with?
What is the firing order for a 1994 Chevy Cheyenne 1500 6cyl?
There should be an engraving/mark on the top of the engine block that says what it is.
What is the firing order for a Chevy 350 5.7L?
The firing order for a Chevy 350 V-8 5.7 is 1-8-4-3-6-5-7-2 and is mark on the intake housing in the top of your engine what is the position of the rotor for the #1 cylinder?
What is the firing order for a 1988 Isuzu Mark 1?
the firing order will be 1342 or 1243
What is the firing order for a 1995 Chevy Blazer S-10?
V6 firing order is: 1-6-5-4-3-2 #1 is the drivers side front cylinder. Distributor rotor rotation is clockwise. I hope this helps you. Mark
Is the firing order for a 1993 Lincoln mark 8 the same as a 1996 mark 8?
Yes
What is the firing order for a 1985 Isuzu I mark?
1-3-4-2
What is the firing order for the coil packs on a 96 mark 8?
click the link.
What mark is your 1996 golf Chico 1.3?
firing order on chico 1.3 golf
What is the firing order jeep scrambler Where do you start counting?
The firing order should be on the intake manifold and you start counting on the cap where it is marked something like one? or a tick mark
What is the firing order for a 1995 Chevy van G20 on the distributor cap which one is number 1 which one is number 2 which one is 3 which is number 4?
The firing order is 1-8-4-3-6-5-7-2. It's a good idea to remove the wires one at a time to avoid headaches. Mark them with a peice of tape with the cylinder number on them.
What is the proper spark plug wiring sequence for a 1993 Honda accord lx?
The firing order is 1,3,4,2. The number one is the one closest to the drivers side tire. There is usually a mark, sometimes an A or A1, on the top of the distributor cap indicating the number one cylinder.
Where are the timing marks located on a Chevy van g20 57l?
If this is a 305/350/400 small block Take the lead from the coil to the distributor "OFF" to prevent the engine from firing. This will take two people or a remote starter. Turn the engine over until the mark on the tortional damper lines up with the center or O mark on the timing tab on the front of the engine fastened to the crankcase front cover and the engine is in the number one firing position. This may be determined by placing fingers on the nuber one valve as the mark on the damper comes near the O mark on the crankshaft front cover.If the valves are not moving the engine is in the number one firing position.If the valves move as the mark comes up to the timing tab the engine is in number 6 position and should be rotated one more complete turn to bring it to the number one firing position. Also take the cover off of the distributor to determine that the rotor is positioned properly pointing to the number one spark plug then follow the firing order for that engine should be 1,8,4,3,6,5,7,2 Wayne
