0
What else can I help you with?
What is the function of the torx?
To turn Torx screws.
What is the function of screwdriver torx?
To turn Torx screws.
How do you remove the tilt knob on a 04 dodge ram?
With a T20 torx screw driver. It is held on by one screw.With a T20 torx screw driver. It is held on by one screw.
What size torx driver for 1998 Dakota taillight assembly?
A torx driver for 1998 Dakota tail light would be size 3157. It is really easy to put in. 3157 would be the bulb size/number. The Torx driver would be a number 15 or 20.
Who makes the best torx bits for an impact driver?
apex.
What size Torx driver is used on Nokia phones?
T-6
What type of screw driver do you need to open a xbox 360 controller?
torx
What is a good substitute for a torx screwdriver?
A flat head screw driver will work if you wedge it in between the security pin and the outside. if it doesnt have the pin, just use a flat head normallyANS 2 -There is NO good substitute for a Torx driver. -That is precisely why they make them. Using other tools on torx bolts will inevitably ruin the bolt head
How do you remove the security torx screw on the 2003 acura tl headlight?
To remove the security Torx screw on the 2003 Acura TL headlight, you'll need a security Torx driver that matches the size of the screw, typically a T20 or T25. First, ensure the vehicle is turned off and the headlights are cool. Insert the security Torx driver into the screw and turn it counterclockwise to loosen and remove. Once removed, you can access the headlight assembly for replacement or repair.
Where is the horn on a vw cc?
Behind the driver side fog light grill. If you have no fog lights its under the grill at the lower front driver side of the car. To pull grill you will need to undo one 20 torx bit. Not 100% sure on the size but I do think the torx was lower than 25
How do you replace the right rear blinker-brake light bulb on a 2000 Dodge Ram 1500 pick up truck?
Put your tailgate down and take the screws off on the inside of the taillight. The screws are Torx screws, so you will need Torx head screw driver. Then just give it a tug and the cover will pop right off. You will be able to change out the bulb.Note: Torx srews are different from Philips or flat-head screws so they require a Torx screw driver which has a star-shaped head.
What is the correct screw driver head and size for Jeep Liberty tail light assembly bolts?
TORX T-15
