0
What else can I help you with?
What size engine mounting bolts on a stx38 john deere?
The engine mounting bolts on a John Deere STX38 typically use 3/8-inch diameter bolts, but it's important to check your specific model's manual for exact specifications, as they can vary. The length may also differ depending on the mounting configuration. Always use the correct grade and size for proper engine support and safety.
What size are the engine mount bolts on a john deere stx38?
The engine mount bolts on a John Deere STX38 are typically 3/8-inch in diameter. It's important to check the specific service manual for your model, as bolt sizes can vary slightly based on manufacturing variations. Always use the recommended torque specifications when reinstalling bolts to ensure proper engine mounting.
What is the size of an jd stx38 drive belt?
The belt is a M74747 which is 1/2" x 105"
What size are the bolts that connect a 4l80e transmission to a 454 engine?
9`16
Size of bolts connecting starter to engine block?
Most likely 1/2"
What size are the engine mount bolts on a John Deere LT155?
I read online on some forum that they are 8mmx25mm bolts and JD part number is 19m7867.
How many bolts on 99 silverados starter?
The starter on a 1999 Chevrolet Silverado typically has two bolts securing it to the engine. These bolts are usually 15mm in size. Always check the specific engine configuration, as variations may exist, but the standard setup generally involves these two bolts.
What is the thermostat location for a 1997 Northstar 4.6?
your thermostat is located on the engine where your lower rad hose goes in your engine two bolts hold the housing on . no gasket sealer is needed
You lost the bolts for your starter?
Depends On What The Starter Is From. Car Model Engine Size, Or Mounting Bolts Ect. If It Is The Bolts That Assemble The Starter< You Can Get These At A Starter Alternator Shop. The Mounting Bolts. Drop By The Dealer Parts House They Can Fix You Up.
Saturn sl1 where's the upper motor mount located How do you replace it?
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
What size are the bolts that connect the engine to transmission in a 1989 Dodge Shadow Turbo?
Should be between 15mm or 18mm
What size bolts are used in a 1972 dodge dart transmission mount-slant 6 auto?
Bell housing to engine block, 4 bolts are 3/8"-16 and 2 bolts are 7/16"-14.
