0
What else can I help you with?
How many quarts of motor oil on 2010 Nissan Rogue krom takes?
4 7/8 quarts with oil filter change 4 1/2 quarts without filter change
How many quarts of motor oil does a 2007 Nissan frontier v6 take?
With filter change it takes 5.5 qts.
What viscosity motor oil does a 1984 Honda GoldWing GL1200 require and how much?
I use SAE 10-40 takes about 3.2 liters. You have a dip stick also.
How do you replace rear windshield wiper blade on 2010 Nissan Rogue?
The 2010 Nissan Rogue takes a special rear wiper blade that you can only get at the dealer because they chose not to use one of the 13 more universal designs that most vehicles use. When you go to the dealer to get the part, ask for installation procedure. You are able to purchase more reasonably-priced aftermarket wiper blades for the front however. See the Sources and Related Links section below.
When does Rogue Wave by Theodore Taylor take place?
"Rogue Wave" by Theodore Taylor takes place during World War II in the Pacific.
What size wiper blades for a 2008 Nissan Rogue?
The 2008 Nissan Rogue takes 26" drivers and 14" passenger side wiper blades. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
How does a falling ball viscometer measure viscosity of a fluid?
A falling ball viscometer measures the viscosity of a fluid by timing how long it takes for a ball to fall through the fluid. The viscosity of the fluid affects how quickly the ball falls, with more viscous fluids causing the ball to fall more slowly. By measuring the time it takes for the ball to fall, the viscometer can calculate the viscosity of the fluid.
Derive the relation between relative viscosity and absolute viscosity?
Relative Viscosity often refers to that of a Polymer Solution and is defined as the ratio of the viscosity of the solution to the pure solvent. It is calculated experimentally by measuring the time that it takes for the pure solvent to pass through a certain tube, in certain conditions , and comparing it with the time it takes for the solution to pass through the same tube, in the same condition. The term Apparent Viscosity is used when you calculate the viscosity of a non-Newtonian fluid by applying equations that are derived for the viscosity of a Newtonian fluid. So it is not the actual viscosity. I hope this answers your question.
Relationship between flow time and viscosity?
The higher the viscosity, the lower the flow rate.
Where are the water pump and thermostat in a 1992 Nissan Sentra and how do you change them?
located between the firewall and the motor on the trans side takes a bit of time and a lot of trouble but you can do it w/o moving the ac lines
If you measure the time it takes for marbles to fall to the bottom of four diffrent solutions that were each in different 100ml cylinders which solution is measured buoyancy mass viscosity or density?
viscosity
What is the difference between effective viscosity and apparent viscosity for Non newtonian fluid?
Effective viscosity refers to the equivalent viscosity of a non-Newtonian fluid under specific flow conditions, while apparent viscosity is a term used to describe the measured viscosity of a non-Newtonian fluid, which may vary depending on the test method used. The effective viscosity takes into account the non-linear behavior of the fluid, while the apparent viscosity provides a simplified representation of its flow properties.
