0
Turn the ignition switch to the OFF position. Remove the air intake cowl weather-stripping. Remove the grill by gently prying out.
- Remove the 2 screws inside the air intake cowl holding the electrical duct.
- Remove the 2 screws holding the right side of the air intake cowl and remove the screw holding the left side. Pull the cowl out from above. It may be very hard to remove, but it will come out.
- On M50 equipped vehicles, remove the injector cover plate and the valve cover cladding from the engine.
- On M50 equipped vehicles, remove the cover from the control unit housing on the right side of the firewall and disconnect the control units plugs. Remove the screws from the injector plug plate and place the plate off to the side. Disconnect the control cable inside the housing.
- Unclip the heater blower cover. Disconnect the wiring from the motor.
- Undo the left flap upper section clips and remove. Disconnect the blower from the brace and remove.
What else can I help you with?
Relay for blower motor for 1993 ford ranger?
Not sure about the relay, but there is a blower resistor assembly located on the heater case to the right of the blower motor.
Where is the blower motor relay in 93 park ave?
The blower motor relay in a 1993 Park Ave is located in the fuse box underneath the hood. The fuse box will be located near the firewall.
How do you install a blower motor 1993 Acura Integra?
The A/C systems blower motor on a 1993 Acura Integra is located behind the glove box on the passenger side of the vehicle. Replacement requires removal of the glovebox, lower passenger dash, and covers. The blower motor is located next to the evaporator, and held by several mounting screws. Just unmount and unplug the blower motor to install the replacement unit.
Were is the blower motor located in a 1993 Honda ex?
Under the dash, located on the passengers side behind the glovebox......
Where is blower motor resistor on 1993 dodge dynasty?
The blower motor resistor is located under the hood, in the right hand cowl, behind the windshield washer bottle.............
How do you replace the blower motor in a 1993 Camaro?
Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
Where is the blower motor located on a 1993 ford explorer?
In the engine compartment on the passenger side - (Helpfull)
Where is the heater blower resistor located on a 1993 Chevy G20 van?
to the left of the blower motor. It's on the left side of the engine compartment
Where is the blower motor relay located on 1993 Chevy pickup?
In the fan box behind the glove box.
Where is the blower motor resistor for 1998 Ford Ranger?
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
How do you change blower motor 1993 ford E350?
i cannot get the wheel off the blower motor
Where is the Heater Blower Motor Resistor located in a 1993 Plymouth Acclaim?
In a 1993 Plymouth Acclaim, the heater blower motor resistor is typically located under the dashboard on the passenger side of the vehicle. It is mounted near the blower motor, often accessed by removing the lower dash panel. You may need to disconnect the wiring harness and remove screws to access the resistor for replacement or inspection.
