In a 2002 Daewoo Nubira 4D SE with a manual transmission, the camshaft position sensor is typically located near the top of the engine, mounted on the cylinder head. It is usually positioned close to the camshaft, often near the timing cover. Accessing it may require removing certain components for better visibility and reach. Always consult a repair manual for specific details and procedures.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
On the Daewoo Leganza it is located behind the AC compressor.
Take plastic engine cover off, which is on top of engine. You will find 4 Allen screws holding the cover in place. The cover is mounted on top of the valve covers. Camshaft position sensor is located to the left of the engine...(looking at engine) you will see two cam gears, sensor is located between the gears. Good luck!
You can find a camshaft positioning sensor and any other Daewoo parts through Lipscomb Mitsubishi. How to change it I don't know if anyone has the answer please E-mail me --I have a 2000 Nubira (2.0L engine) and the camshaft position sensor is located inside the timing belt cover, on the passenger side of the engine, and behind the timing belt. The right engine mount bracket has to be removed so make sure you support the engine first--the alternator seems to have a pretty stout bracket to place the support under. The sensor is located towards the very top, behind and between the two camshaft sprockets/gears.
There is NO TRANSMISSION DIPSTICK on the Daewoo Lanos
Where is the crankshaft sensor on daewoo cielo glx 1996 dohc.
what is the timing marks on the camshaft what is the timing marks on the camshaft
For DOHC engines its located under the sparks plugs cover near the camshaft sprocket.salehanzi@yahoo.com
only one
yes
I started by removing the camshaft cover, then I realized the many other parts have to be removed before being able to succesfuly replace the sensor.... I also would like to know the procedure. Thanks