0
What else can I help you with?
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
How do you replace a camshaft position sensor on a 2000 Nissan Xterra?
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Do you have to replace anything else along with the camshaft sensor?
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
How to replace 2004 Nissan maxima camshaft sensor?
Did you figure out where this sensor is located
How do you change a camshaft sensor on golf gti mark 3?
The camshaft sensor is located in the distributor. I believe you have to replace the hole distributor.
Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
How do you replace the camshaft positioning sensor ml27 cdi?
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
Why would there be oil in your camshaft sensor on a 1997 dodge neon?
Rear camshaft seal bad. Replace. located behind cam sensor.
Where can you find the camshaft position sensor on a Nissan Altima?
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
How do you replace a cam shaft sensor and where is it located on a 2000 s40 Volvo?
Camshaft sensor is located at rear end of rear camshaft(near driver). It is screwed on the little bowl and has a connector attached to it. The little bowl contains the camshaft sensor gear , do not unscrew if not necessary , just replace sensor. Jules
How to replace camshaft position sensor for vw jetta 1999?
how to remplace position of oxigen sensor
