0
The coolant level sensor on a Buick 3800 engine is typically located in the coolant reservoir tank. It is designed to monitor the level of coolant and send signals to the vehicle's dashboard to alert the driver if the coolant level is low. To access it, you may need to remove the reservoir tank, which is usually secured by clips or bolts. Always consult the vehicle's service manual for specific instructions related to your model year.
What else can I help you with?
Where is the knock sensor on a 1992 Buick Regal 3800?
Where is the knock sensor located on a 1992 buick regal
Buick 3800 crank position sensor?
behind the crank pulley
What is the coolant capacity of a 1997 Buick Riviera 3800 supercharged engine?
how many gallon radiator is the 1997 buick riviera
Where is the oxygen sensor on a 1990 Buick Le Sabre 3800?
The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.
Where is the control temperature sensor on a 92 pontiac bonneville 3800?
I have a 92 Buick Riviera 3800. The temp sensor on my car is just underneath the throttle body... driver's side of the engine
Where is the coolant level sensor on a 1999 grand prix gt 3800 v6?
99 Grand Prix Coolant Sensor InfoThe coolant level sensor on this car in called a "coolant level indicator module" and is a small square box attached to the RH (pass.)side of the rad,engine side(rear)of the side tank,about 1/2 way down.The wiring plugs in from the bottom. It is held in by a snap clip and seals with an o-ring.Submitted by Andrew at Zippy's Auto in Edmonton Alberta Canada
Where is the coolant temperature sensor located in a Pontiac firebird 2002?
on the 3800 V6 its below the throttle body
What is the screw on top of the thermostat housing on the Buick 3800 engine?
Its the bleeder screw, its used to let air pockets out the coolant system.
Bleed 3800 engine cooling system?
Is the question how to bleed a Buick 3800 cooling system? I would say open that little petcock by the themostat housing and release all the air as you fill the system with coolant. When coolant comes out instead of air all the air is out.
Where is the temp gauge sensor on a '1997' camaro 3800?
look under the throttle body on the front of the engine there s a sensor with 3 wires going to it that is the engine coolant temperature sensor
How do you replace the crank sensor on a 1989 Buick Reatta 3800 engine?
To replace the crank sensor on a 1989 Buick Reatta with a 3800 engine, first, disconnect the negative battery cable to ensure safety. Locate the crankshaft position sensor, which is typically found near the crankshaft pulley. Remove the sensor's electrical connector and unscrew the mounting bolt to take it out. Install the new sensor by reversing the process, ensuring that it is securely fastened and the connector is properly attached before reconnecting the battery.
Where is the coolant drain plug on the 3800 engine block of a 93 buick lesabre?
Should be a plastic key shaped thing. bottom of tank, corner, engine side.
