In a 1997 Jeep Wrangler, the fuse for the headlights is located in the fuse panel, which is typically found under the dashboard on the driver's side. You can identify the correct fuse by referring to the fuse diagram, usually found on the cover of the fuse panel or in the owner's manual. The headlight fuse is usually labeled clearly, making it easier to locate and check if it needs replacement.
fuse 14 (20 amp) in fuse box
The same Ones I take out.
If the headlights do not come on and the parking lights do in a 2000 Jeep Wrangler, it is possible that the fuse is blown for the headlamps. It is also possible for them to both be burned out due to touching the glass part when installing them. Oil in the fingers will overheat them and burn them out.
Behind glove compartment fuse # 15 or # 14, depends on the model but it is marked on the legend.
Most headlights are not fused they are wired direct thru the headlight switch... Is your switch bad??
A 2008 Jeep Wrangler has one fuse box, it is under the hood next to the battery.
In a 2000 Jeep Wrangler, the headlight fuse is located in the fuse box under the dashboard on the driver's side. To access it, remove the cover of the fuse box and look for the fuse labeled for the headlights, typically a 15-amp fuse. If you need to replace it, ensure the vehicle is turned off before doing so. For specific locations, you can refer to the diagram on the fuse box cover.
Yes.
All fuses on a 2011 Jeep Wrangler are under the hood next to the battery.
No, there is no fuse for the crank sensor
On my 2002 wrangler you have to put a fuse in the fuse box behind the glove box. I think it says transmission but this will allow you to start the Jeep without having to push in the clutch.
If a 1999 Jeep Wrangler dash gauge stops working, check the fuse. The fuse may have blown out and will need replaced.