answersLogoWhite

0

The knock sensor on a 2004 Honda CR-V is typically located on the engine block, near the oil pan. Specifically, it can be found on the driver's side, between the engine and the transmission, often mounted to the engine's cylinder block. Accessing it may require removing certain components for better visibility and reach.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where is the rear wheel abs sensor on a 1998 Honda CRV?

Where is the rear wheel abs sensor on a 1998 Honda CRV?


would a 2004, 2005, Honda CRV rear end differential fit Honda 2007 CRV?

would a 2004, 2005, Honda crv rear end differential fit Honda 2007 crv.


Where is the Location of throttle position sensor on Honda 2004 crv?

It is on the throttle body just below the throttle linkage.


How much does it cost to get a co2 sensor repaired on a Honda 2001 CRV?

I want to replace the co2 sensor in my crv myself is it something I can do?


Where is the crankshaft postioning sensor located at?

Honda crv 2002


How do you replace license plate bulb on 2004 crv?

how do you replace a honda crv licence plate bulb on a 2004


How often to change timing belt 2004 Honda crv?

You don't as the 2004 Honda CRV uses a timing chain and not a belt. It should last the life of the engine.


Were is the secondary 02 sensor located?

where is the secondary 02 sensor on a 2004 crv


Where is the air conditioning compressor fuse for Honda cr-v 2004?

where is the fan fuse on a 2004 honda crv


2004 Honda crv cruise control does not work when headlights are on?

mY hONDA crv CRUISE CONTROL WAS WORKING UNTIL NOW EVEN WHEN HEADLIGHTS WERE ON. bUT IT STOPPED WORKING EVEN THOUGH HEADLIGHTS ARE ON OR NOT.........PLEASE HELP


Can you change the fuel filter on 2004 Honda crv without relieving the fuel pressure?

No. DO NOT ATTEMPT IT!


Where is the throttle position sensor located on a 2004 Honda crv?

On a 2004 Honda CR-V, the throttle position sensor (TPS) is located on the throttle body, which is situated on the intake manifold. It is typically mounted on the side of the throttle body and is connected to the throttle plate. To access it, you may need to remove the air intake duct and other components for better visibility and reach.