the thermostat is located in the housing where the top radiator hose enters the engine. Note: there is also a brass screw on the top of the housing, this is to bleed the air from the cooling system when you replace the thermostat (or do other cooling system repairs)
To use Bar's Radiator Stop Leak in a 2000 Saturn S-Series sedan, first ensure the engine is cool and the radiator cap is removed. Pour the stop leak directly into the radiator or the coolant reservoir, depending on where the leak is located. After adding the product, run the engine to allow it to circulate through the cooling system. Always follow the manufacturer's instructions on the product for best results.
what is the radiator capacity on my 97 delta olds with a 3800 series engine The radiator only holds about 3 to 4 qts. The entire cooling system holds about 12 qts.
The cooling systems is a closed system with the resiviour part of that system. Coolant is added to the resiviour cap. This is different from other cars as the resiviour is not usually pressurized. In the s-series it is.
You fill it though the resivoir cap
To my knowledge all thermoststs are located at the end of the top radiator hose !
On a 2001 Saturn L-Series, the radiator cap is located on the top of the radiator itself. It is typically a circular cap that can be unscrewed for coolant access. Ensure the engine is cool before attempting to remove it to avoid injury from hot coolant or steam.
The radiator symbol on a car dashboard typically resembles a stylized radiator or cooling system with a series of horizontal lines and a small cap or lid at the top. It often appears as a rectangular shape with a few vertical lines representing the fins. When illuminated, this symbol usually indicates a problem with the engine's cooling system, such as low coolant levels or overheating.
If your 60 series Detroit is pushing water out of the radiator, it could be due to several reasons. A common cause is a blown head gasket, which can allow combustion gases to enter the cooling system and create excessive pressure. Other possibilities include a malfunctioning radiator cap, a plugged cooling system, or a failing water pump that isn't circulating coolant effectively. It's advisable to conduct a thorough inspection to pinpoint the exact issue and prevent further damage.
The cooling systems is a closed system with the resiviour part of that system. Coolant is added to the resiviour cap. This is different from other cars as the resiviour is not usually pressurized. In the s-series it is.
Should be in a removable housing at the engine end of the upper radiator hose
A device on a water cooled engine for storing and cooling the liquid coolant. It contains a series of pipes or tubes that are used to transfer heat from a incoming fluid within the radiator to an area outside the radiator. Air flows through the radiator and removes heat from the coolant before it is pumped back into the engine. This cycle continues as long as the engine is running.An engine-cooling device in a motor vehicle or aircraft consisting of a bank of thin tubes in which circulating fluid is cooled by the surrounding air.