because you forgot to put lube on it
The hot wire is typically connected to the line terminal.
To wire a 3-prong plug with 4 wires correctly, you will need to connect the green wire to the ground terminal, the white wire to the neutral terminal, the black wire to the hot terminal, and the red wire to the second hot terminal. Make sure to follow the specific instructions provided with the plug and consult a professional if needed.
Yes-connect the black wire to the brass terminal and the white wire to the silver terminal.
To wire a switch leg correctly, connect the hot wire to the common terminal of the switch, the switched hot wire to the other terminal, and the neutral wire to the neutral terminal. Make sure to turn off the power before starting and follow the wiring diagram for your specific switch.
To wire a switch to a light, you connect the hot wire from the power source to one terminal on the switch, then connect another wire from the other terminal of the switch to the hot terminal on the light fixture. Finally, connect the neutral wires from the power source and the light fixture together.
To properly wire a half hot outlet in your electrical system, you will need to connect the hot wire to the brass terminal, the neutral wire to the silver terminal, and the switched hot wire to the other brass terminal. Make sure to turn off the power before starting and follow all safety precautions. It is recommended to consult a professional electrician if you are unsure.
Amperage is always measured with the guage in series with the hot wire. That is the one wire is cut and the guage goes in line as opposed to some devices which have a hot and neutral (or ground).
The 4-wire light fixture wiring diagram for this installation involves connecting the black wire to the live or hot terminal, the white wire to the neutral terminal, the green or bare wire to the ground terminal, and the red wire to the switch terminal for controlling the light.
To wire a light switch to an outlet, you need to connect the hot wire from the outlet to the hot terminal on the switch, and then connect the hot wire from the light fixture to the other terminal on the switch. Make sure to turn off the power before starting and follow all safety precautions.
The correct wiring diagram for an outlet and switch setup involves connecting the hot wire to the brass terminal on the outlet, the neutral wire to the silver terminal, and the ground wire to the green terminal. For the switch, connect the hot wire to the brass screw, the switched hot wire to the black screw, and the ground wire to the green screw. Make sure to turn off the power before working on any electrical connections.
To properly wire the light and fan switches in your room, you should connect the hot wire from the power source to the common terminal of each switch. Then, connect the hot wire from the light fixture to the terminal on the light switch and the hot wire from the fan to the terminal on the fan switch. Finally, connect the neutral wires together and the ground wires to the grounding terminal. This setup will ensure that the switches function correctly and control the light and fan independently.
assuming that no one has cut a wire, the alternator is probably bad. could be a fuse. Depending on car, it could be a fusible link. Process of elimination. The main large wire on the back of the alternator runs to the battery. Should be smaller wire on the positive cable.