0
What else can I help you with?
How does a seat belt sensor work?
Seatbelts save many lives around the world each year. However, cars still remain among the most dangerous methods of transportation. Seat-belt are found in the latch mechanism. If the magnet does not sense the belt connected it will alarm you with a noise and a sign on the dashboard.
Will airbag work if seat belt is fastend?
Yeas it will
Your remote control for alarm on pt cruiser doesn't work?
alarm doesnt wrk neither does door locks with key
Will your alarm clock on your cell phone work where there is no signal?
yes it will cause it doesnt use the signal to set the alarm or time.
What to do if passenger seat does not always heat up?
The seat belt has to be ingaged for heater to work. The seatbelt has to be ingaged to work
How do you harness 3 in 1 car seat?
there are seat belt extenders that might work
How does seat belt locks work?
Seat belt locks work by using a mechanism within the seat belt retractor that engages when the belt is pulled out and suddenly released. This mechanism, often a locking latch plate or a retracting spool, prevents the belt from retracting, securing the occupant in place during a sudden stop or collision. Some vehicles also have an additional feature where the seat belt locks when the vehicle is in a crash or if the belt is anchored incorrectly. This ensures that the seat belt remains tight and effective in protecting passengers.
Will air bag work if seat belt is not fastened?
Yes.
How do you turn off the seat belt alarm off on a 2004 f 250?
You can't. Its part of the computer. Maybe the dealer can? The work around my boss uses is plugging in a seatbelt extension which is around $25-$50 from a dealer
How do you deactivate the seat belt minder in a 2004 ford escape?
here you go try going here first www.ebookspdf.com/automotives/3189/ford-escape-2001-owners-manual/and if that doesnt work try what i did get in like ur going somewhere without ur seat belt on put ur key in to the on position but dont turn it on wait till the seat belt light goes off then pull ur seat belt in and out 3 times then real fast turn ur light on then off then real fast pull ur seat belt in and out again 3 times then in 5 sec. pull it back in and out then the seat belt light should flash 4 times or so if u done it right hope this help.
When should you change a timing belt on a 2003 Mitsubishi galant?
when it doesnt work
Are seat belts effective at low speeds?
no if you have the type of seat belt that you can keep pulling. They only work at higher speeds.
