Usually if you have full field the armature rpm is dependent on the armature voltage. If the power source can supply current enough for full load torque or stall torque, the motor endeavors to take all the power it needs to be at full speed. In short, if there is inertia in the load, you may break the motor's output drive couplings and gears if you don't limit the starting current by using a resistor.
describe how to use starting resistors to star a DC motor
A series-wound commutator motor has the best starting torque because the torque is proportional to the square of the current, and the starting current is set by a current-limiting resistor which is switched out as the motor builds up speed.
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
The 2005 Pontiac fan motor resistor is located on the back of the fan motor. The fan motor resistor is attached to the fan motor with two retaining screws.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
The blower motor resistor has failed.The blower motor resistor has failed.
No, a 4160 volt motor with a high inertia load will use a resistor bank in the starting of the motor.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
The blower motor resistor is generally located close to the blower motor.
Resistor is a separate unit from the blower motor
where is the blower motor resistor in a 2003 Mitsubishi eclipse
A series DC motor has to have a starting resistor to limit the current flow before the speed builds up.