0
A bad AC heater blend door actuator itself won't directly stop the compressor from working, as its primary function is to control the airflow direction and temperature within the cabin. However, if the actuator is malfunctioning and causing issues with air temperature regulation, it may affect the overall performance of the HVAC system, leading to perceived cooling issues. If the system isn't cooling properly, it may seem like the compressor isn't functioning, but the underlying problem is likely related to the blend door actuator or other components.
What else can I help you with?
Where is the blend door actuator on your 1997 F150?
How do I locate the heater blend door actuator in a Ford f150 pickup
How do you replace 1994 gmc sierra heater blend door actuator?
bs
Where is the blend door actuator located on 95 gmc sonoma?
The temperature valve actuator is located on the front of the heater case
Where is the vacuum line for the heater blend door on a 2000 Chevy blazer s- 10?
The heater blend door is not run by vacuum. It is run by an electric actuator.
Why is the heat not working on your 2006 Chevy Impala?
Assuming the blower motor is working, it could be low on coolant, a stuck open thermostat, a plugged heater core or a faulty temp blend door actuator.
Could it be the blend door actuator that is not allowing your heater to go off?
Yes, it is possible the blend door is broken in the heat position.
What would make the heater not work in a 1999 windstar?
Not a whole of symptoms to work with here...The most common cause of "... heater not working..." is a failed temperature blend door actuator motor.See "Related Questions" below for more
How do you fix a clicking in the heater and air conditioner switch on a Ford?
You have a faulty temperature blend door actuator located directly behind the radio. Remove the radio and remove the blend door actuator held to the heater case with three 8mm screws, and replace it.
How do you change heater door motor on a 1999 mercury marquis?
I believe you are looking for blend door actuator???
Your front heater does not get hot but the rear works just fine on your 1998 Expedition?
Does your blower motor work? If it does and there is no heat the blend door actuator is probably not working and is not letting warm air into the vehicle. The blend door is staying in the cold position.
What would be wrong if heater and ac dont work and its not heater core?
First check the fuses then check your blower fan then check the blend door and blend door actuator and then the control panel
Heat will not come on only cold air yet fans still working?
Could be, low on coolant, faulty thermostat, plugged heater core, faulty temp blend door actuator.
