0
What else can I help you with?
How do you install timing belt 1993 Honda Acura Vigor 2.5?
you have to remove the radiator and fans the main crank pulley and that should get you to the plastic cover take that off and then loosen the tension pulley and i would recommend changing the water pump and gasket at the same time
What would be the technical name for a tension pulley for a 1997-1999 eclipse?
belt tensioner
Why would 98 ford Taurus be making noise if you changed the serpentine belt idler pulley and tension pulley?
replace the belt with a goodyear bet
Where is the tension bolt on a 1992 Chrysler new yorker alternator?
Assuming you have a serpentine belt on that 3.3L engine, the tension on the alternator would be controlled by the idler (tension) pulley. The alternator is stationary.
How do release the belt tensioner on Chrysler lebaron?
you have to push down on the tension pulley, then you would get slack in the belt
Would a bad tension belt or pulley make your car whine?
Yes. I have had to replace tensioners for this reason.
What kind of tool do you use to loosen tension pulley on a 2002 cavalier?
You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.
What is a idler pulley used for on a ford bronco?
The idler pulley on any vehicle is used to maintain the proper tension on the vehicle's belt(s). without it belt maintenance would be difficult.
What way dose ldler pulley bolt turn to remove pulley?
depends on the car. Put a wrench on it and turn both ways till you see some movement. You can't really break anything but it shouldn't be difficult to turn at all even with the tension from the belt. I would think if the belt runs on top of the pulley it would turn CCW and if it runs below the buttom probably clockwise would release the tension.
What is an example of a pulley on a bicycle?
Bicycles with external gears have two, one guide pulley and one tension pulley, both in the rear derailleur. Some bicycles have further pulleys on the frame for either the brake or the shifter wire to run over.
Why would coolant be leaking from behind the main pulley on a 96 V6 Oldsmobile Achieva?
Sounds like water pump needs replacing The main pulley is near the top of the engine. The water pump is toward the front of the engine. It is possible that water appears to be leaking from this pulley, but there is a manifold gasket right above it. Double check to find exactly where the water is exiting the engine block. My first hunch is a leaking gasket.
Is a 2000 s-10 4.3litre water pump standard or reverse rotation?
The water pump would be a standard rotation. The serpentine belt moves clockwise on the model truck which would make it standard not reverse. With a serpentine belt system like the one in the 2000 S10 4.3, any pulley that is grooved turns clockwise. Any pulley that is smooth turns counterclockwise. The water pump pulley on that S10 is smooth and turns CCW.
