0
Check to see if there is a fusible link in line with power to your starter solenoid. If you aren't sure disconnect your battery ( both cables, neg first ) and use an ohm meter to check for continuity in your main positive battery cable. Did you check to see if you battery will hold a charge? The easiest way to do this is take it to a parts store for a free test. If the battery fails the test it could have been damaged by a faulty voltage regulator. If you take your battery to the shop for a free test might as well take your alternator along at the same time.
What else can I help you with?
96 jeep grand Cherokee that shut down you have replaced the coil fuel relay ASD relay fuel pump What else could it be There is no power to the dash board gauges fuel pump and ignition system?
Blown fuse or bad ignition switch or crank sensor?
Why does your Oldsmobile alero hesitate before starting?
you need to re-do the timing of the ignition system. the other possibility is the ignition is worn out and needs to be replaced.
I have replaced everything involved in my ignition system but still lose spark after driving for a short period of time if you le tit sit for an hour it will restart again any suggestions?
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.
How do you bypass anti-theft system on Ford Ranger?
How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition
Why does my 1993 Jeep Cherokee keep running even after ignition switch is cut off?
If your 1993 Jeep Cherokee continues to run after the ignition switch is turned off, it may be due to a faulty ignition switch or a problem with the ignition system, such as a short circuit. Another possibility is that the engine is experiencing "dieseling," where fuel continues to ignite in the cylinders after the ignition is turned off, often due to carbon buildup or an overly rich fuel mixture. Additionally, check for issues with the fuel system or relay that might be causing the engine to keep receiving power.
What is the age of a smooth bore flintlock?
The flint ignition system was invented in the 16th century and became 'standard' in the 17th century. It was replaced by the percussion system in the mid 19th century.
2002 Jeep Grand Cherokee Engine cranks but is a no start No dash gauges?
A 2002 Jeep Grand Cherokee engine that cranks but is not starting and has no dash gauges is experiencing an electrical system failure. This can be a result of a faulty ignition switch or damaged wiring.
What do you do if your Chevy Malibu will not start after you replaced the ignition?
you did not mention what year, but are you sure it was the ignition and not the anti theft system. If you think it could be the anit theft system, than you can try turning the key on for 10 minutes and than off for on e and repeat this and than see if it starts.
What causes backfire of a 2001 Jeep Cherokee?
Backfire in a 2001 Jeep Cherokee can be caused by several factors, including issues with the ignition system, such as faulty spark plugs or a malfunctioning ignition coil. Additionally, problems with the fuel system, like a clogged fuel filter or a malfunctioning fuel injector, can lead to an improper air-fuel mixture, resulting in backfire. Timing issues, such as incorrect ignition timing, can also contribute to this problem. Regular maintenance and timely repairs are essential to prevent backfire and ensure optimal engine performance.
What could cause a 1971 Chevelle Malibu to start but doesn't shut off when you replaced the ignition switch but nothing changed Besides the whole ignition system what else could it be?
Something is keeping power to the ignition coil. You need a wiring schematic and trace the wiring.
A primary advantage of the electronic ignition system over conventional ignition systems is?
a primary advantage of the electronic ignition system over conventional ignition system is?
What causes the ignition switch to rotate without powering up the ignition system and not starting on a 1984 Chevrolet pickup with tilt steering?
If your battery is fully charged and the connections are clean and tight, the problem is probably that the contacts in the switch are corroded or worn, meaning your ignition switch will have to be replaced.
