To change the thermostat on a 2003 Pontiac Montana, start by ensuring the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with a new one (making sure to align it correctly), and reassemble everything by reconnecting the hose and refilling the coolant. Finally, reconnect the battery and check for leaks after starting the engine.
To change the thermostat on a 2003 Pontiac Montana with a 3.4L engine, start by allowing the engine to cool down completely. Then, drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing to access the thermostat, replace it with a new one (ensuring the gasket is in place), and reassemble everything by reversing the steps. Finally, refill the coolant and check for leaks before starting the engine.
Should be located at the engine end of the upper radiator hose in removable housing
Jack up vehicle and change the rear plugs from underneath!
The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.
they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana
AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....
Under the steering wheel
No
The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.
The spare tire on a 2003 Pontiac Montana is under the vehicle behind the back bumper. It is lowered from the inside using the lug wrench on the tire iron.
Look in the glove box there is a black door open it and its there
Push the "mode" button that is on the console to the right of the drivers head , until the kph changes to mph