in a bath of costic soda
You should use a torch for soldering a radiator. Torches provide a more controlled and even heat, making it easier to solder the joints effectively. Soldering guns are typically not recommended for radiator repair as they can overheat and damage the radiator.
The soldering stand has a wet sponge on it so you can wipe off and clean the soldering iron!
yes you can, so long as you clean the metal before hand like in usual soldering
Yes, excessive soldering can damage an aluminum radiator. High heat from excessive soldering can cause the aluminum to weaken, warp, or even melt. It is best to use the correct amount of solder and maintain proper soldering techniques to avoid damaging the radiator.
Flux is used in soldering to clean metal surfaces, prevent oxidation, and facilitate the flow of solder. Cleanliness of metals is important in soldering because any contaminants on the metal surfaces can prevent the solder from properly adhering, resulting in weak or unreliable connections. Ensuring the metals are clean before soldering helps to achieve strong and reliable joints.
You could try soldering
A: The pad is not clean it has tarnish or wrong solder with not enough soldering flux. Finally not enough heat.
drainit
Make sure the soldering copper (tip) is clean and free of oxidation add some type of non acid flux and do not over heat
To effectively seal a copper pipe, you can use a soldering technique. This involves heating the joint where the pipe connects and applying solder to create a watertight seal. Make sure to clean the pipe and fittings thoroughly before soldering to ensure a secure bond.
Borax is used as a flux in soldering to clean the metal surfaces being joined and to prevent oxidation during the soldering process. It helps the solder flow more easily and create a strong bond between the metals.
No, soldering and brazing fluxes are not the same. Soldering fluxes are designed to remove oxides from the metal surfaces being joined during soldering, while brazing fluxes are formulated to clean the joint and promote wetting for the filler metal in brazing processes. Additionally, brazing fluxes can handle higher temperatures compared to soldering fluxes.