0
What else can I help you with?
What causes a knock sound in rear of 2001 Saturn wagon strut system?
A loose strut. There is a nut at the top of the strut that is sort of difficult to tighten. Get a box wrench for the nut and slip it over the strut shaft. Notice the top of the shaft of the strut - it's not exactly round. It's sort of oval, thus enabling you to hold that with vice grips. Place the vice grips on the shaft. Hold the vice and tighten the nut. Don't over tighten Same thing happened to my car. Hope this helps.
How do you replace wheel bearing assembly on 98 Malibu?
After you remove the wheel, remove the caliper and caliper mounting bracket. There is a nut on the end of the axle shaft. Remove the nut. There are three bolts on the back of the steering knuckle that hold on the wheel bearing. Remove these bolts. Then with a punch or chisel and hammer, strike the axle shaft until the old bearing comes out. Reverse procedure to install. Don nut re-use the axle shaft nut. Do not under- or over-tighten the axle shaft nut. Torque for the nut is 180 ft lbs.
How do you install a governor on a 5hp Briggs and stratton engine?
You loosen the nut own the governor arm turn the arm clockwise and then turn the governor shaft clock wise. Tighten nut That should do it.
How do you change a differential pinion seal on a Holden commodore?
You need to mark the position of the nut prior to removing.. a centre punch mark on the nut and shaft. Remove nut and flange pry out the seal and replace install the flange and nut Tighten the nut until the centre punch marks line up again
1999 Chrysler Town and Country starter installation?
To install the starter, hold the starter motor spacer in position, install the starter motor-to-transaxle bell housing bolts, tighten it, and engage the solenoid wiring connector onto the terminal. Then, connect the B+ wire, tighten the retaining nut, lower the vehicle, connect the negative battery cable and verify starter motor operation. ÊÊ
1999 Chevy Tahoe limited and replace ignition switch and safety neutral switch and vehicle will not crank like it was in D and also replaced and checked starter relay and crank fuse tested starter?
tighten the nut from the starter to the solenoid
How do you reset wiper motor so wiper arent blocking your view?
Reset the wiper arm. At the bulkhead end of the arm is a big nut on a tapered shaft. (might be under a cover). Slacken the nut and loosen the arm from the tapered shaft. Move the wiper to a different position on the windshield and tighten the nut. Test wiper to see that blade returns to the new position.
Why won't the lock nut tighten properly?
The lock nut may not tighten properly due to incorrect threading alignment or damage to the nut or bolt. It is important to ensure that the threads are clean and properly aligned before attempting to tighten the lock nut.
How do you tighten the steering?
To tighten the steering you just tighten the nut under it and then your done. NICE
How do you tighten an aircraft nut?
The same way you tighten any other nut. Use the appropriate tool to the recommended specifications.
What can you do with a nut driver?
Tighten the proper size of nut. Or loosen same.
How do you replace Shift Lever tube Bushing ford ranger 98?
If it is a manual Ford Ranger 98, simply open the boot at the base, remove the nut that is on the bolt, put the nut on the other side and tighten it there instead. Then the bolt will be forced out of the shaft.
