A maximum of three to four shims is recommended.
The alignment of a pump is the process of making sure the pump shaft and prime mover (electric motor, engine,ect.)shaft are lined up perfect both horazonally and verticaly to ensure there is no binding on the coupling.
The maximum amperage requirement for a well pump typically ranges from 10 to 20 amps, depending on the size and type of the pump.
The maximum vacuum pressure in psi that can be achieved by the vacuum pump is 29.92 psi.
Injector timing on b6000 is adjusted by adding or subtracting shims under the injector pump. Timing should be set with fly wheel timing mark on cyclinder #1
The maximum gallons per minute (GPM) capacity of a sump pump typically ranges from 30 to 100 GPM, depending on the model and size of the pump.
Fuel pump pressure (Maximum) 75 psi
To line up a pump shaft, start by ensuring that both the pump and motor are securely mounted on a stable base. Use a dial indicator or laser alignment tool to measure the alignment between the pump shaft and the motor shaft at both the vertical and horizontal planes. Adjust the position of the motor by shimming or moving it until the shafts are properly aligned within the manufacturer's specified tolerances. Finally, recheck the alignment after securing all bolts to ensure that no movement has occurred during the tightening process.
The specs vary on each and every pump. You have to check with each one.
maximum current of a 1hp
This varies from pump to pump because centrifugal pumps can be designed for various applications. The maximum height a pump can pump water depends on size of pipe/water column, friction, power available etc. This is often reffered to as the head of the pump. A water company would probably have some centrifugal pumps capable pumping to over 300m in a 30 inch main.
The specs vary on each and every pump. You have to check with each one.
The maximum distance will be relative to the efficiency of the pump and the rated flow of the pump vs the size of the suction hose. The more efficient the pump, the more vacuum it can draw, and the larger the suction hose in relation to the flow rating of the pump the farther you can move the pump away from the water. The manufacturer of the pump will have charts that will help you properly size and set up your pump for optimum performance.