it could be your crank shaft censer
my ranger will not crank unless the clutch is pushin. could it be a relay
yes, that could be a cause. Along with fuel pump, crank sensor,....
Where is the crank sensor located on a 94 ranger 4.0 motor
It could be low fuel pressure caused by weak fuel pump or restricted fuel filter.
could be many things, probably a crank sensor
Could be a bad battery or starter.
Next to the crank pulley. Held on with 2 10mm bolts.
Perhaps a blown fuel pump. Take a plug wire out and use a spare plug and set it on a piece of metal and crank it and look for the spark. This will eliminate an ignition problem.
haha i asked this question and i can answer it now. I finally got my truck on the road !!
Yes. The Crank sensor monitors the position and rotational speed of the engine to determine timing for ignition. if it is not functioning you will get no spark.
you just do what mark on the crank is TDC
its junk! crush it!