In a BMW 528i, the crankshaft position sensor is typically located near the bottom of the engine, often on the engine block or transmission bell housing. It is positioned to detect the position of the crankshaft, and accessing it may require removing some components, such as the air intake or engine covers, depending on the specific model year. Always refer to the vehicle's service manual for precise location and replacement instructions.
Located next to the crankshaft pulley
http://forums.bimmerforums.com/forum/showthread.php?t=886595
I mean a Trans position sensor I mean a Trans position sensor
On a 97 528i the speed sensor is located on the transmission tail shaft housing at the top.
Bmw 528 1997 not start
Left side upper portion of the radiator.
The Vehicle Speed Sensor will be on top of the transmission, at the transmission output. Wheel Speed Sensors will be located at each wheel.... the latter are for ABS.
I am not a mechanic but just had the crank sensor replaced on my 328 (M52) and found a good write up on the net. I think it is the same engine so below is a web link on how to do it. http://www.pelicanparts.com/bmw/techarticles/101-Projects-15-Crankshaft-Sensor/101-Projects-15-Crankshaft-Sensor.htm Hope this helps Andre
I would like to know, where the ac blower is located on a 1999 BMW 528i
I would assume not as the sensor is needed to calibrate & adjust spark timing & fuel delivery. However not being a qualified BMW mechanic this is only my opoinion. Hope this helps?
On a 2000 BMW 528i, the speed sensor is typically located on the transmission. Specifically, it can be found on the driver's side of the transmission housing, near the output shaft. To access it, you may need to lift the vehicle and remove any protective covers or components obstructing the sensor. Always consult a repair manual for detailed instructions specific to your vehicle.
It looks like this: