0
A 2000 Ford Excursion may stall when put in reverse due to several potential issues. Common causes include a malfunctioning idle air control valve, which regulates engine idle speed, or a vacuum leak that disrupts air-fuel mixture. Additionally, problems with the transmission or electrical system, such as a faulty sensor or low fluid levels, could also lead to stalling. It's advisable to have the vehicle diagnosed by a mechanic to pinpoint the exact issue.
What else can I help you with?
If i put my 2000 ford excursion 6.8 v10 auto. tranny into gear it dies right away?
Are you putting it in reverse? Sometimes when the Transmission Fluid is very low, and you have been driving, then stop to put into reverse, the engine will cut off. Ck Trans. Fluid.
Why does 93 Mazda mx6 stall when put in drive or reverse ive driven it for almost 4 months then all the sudden this its fine when its in drive or neutral but if i put it in park or drive it dies?
It might be a problem with your transmission because not all mx6's stall when you put it in drive or reverse.
What causes an automatic transmission not to idle?
If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"
Why would an engine seem to almost stall when put in reverse but idle fine in park engine is 94 351 windsor?
Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?
Why does your Ford F-250 stall when put in reverse?
No, that would indicate transmission problems, is it a standard or and auto?
Why does your car stall when you press the gas pedal or you put it in reverse?
youre lifting the clutch up to quick
Recently removed and reinstalled 72 Vw enigne. When I put it in reverse why does it cut off?
Check the wires on the coil. If a couple are swapped to wrong positions, the car will run, but immediately stall when put in reverse.
Why would your 1995 Buick run in park neutral and drive in reverse but stall when put in drive?
* cause it needs to be put in drive to go forward
Why does my car die when I put it in reverse?
Sometimes the torquconverter can fail causing the engin to stall. In reverse it lock in full torqu. In fwd gears it slips. This is only one idea.
Why would a 1992 Ford F-150 stall when put in reverse?
could possibly be the torque convertor. wiil it go if you give it some gas going from neutral to reverse or does it still stall ? check shift linkage for pinching a wire when shifted , good luck !
Why would the engine almost stall in a 1996 ford f150 5.0 when put into reverse?
transmission filter not properly seated in the valve body, causing it to stall when engaging reverse gear, wouldnt have believed it if i personally hadnt experienced the exact same problem myself.
Why does a Dodge truck stall when put in reverse?
If it is a standard transmission, you would need to slowly let out the clutch while backing up.
