Have vehicle scanned to determine the problem
Why do interior lights stay on when engine is shut off on 2001 Lincoln Continental car?
If the interior lights and overdrive are also not working then is a fuse. Look in the owners manual to see which fuse.
yes, because your lights run on your car battery
Headlights, interior lights, parking lights,Headlights, interior lights, parking lights,
interior fuse is located in engine compartment in fuse panel marked memory 15amp. fuse.
Try turning them off. This is done with the dimmer control of the dash lights.
Check the fuse box in the engine compartment, also you need to check the lights itself. You might have to replace it.
The ABS light indicates a problem with the anti-lock brake system, the airbag light is a problem within the airbag system and needs to be checked as soon as possible, the engine light is a malfunction with the engine after start up, the battery light shows the battery is no longer being charged, the EPC light is a fault in the engine. There are also some other lights that are self explanatory, and can be found in your car's manual.
I think you are asking about a computer. There are a couple. PCM- engine, ABS-antilock brakes, Airbag - safety restraints, Cluster, Front controller (part of under hood fuse box, runs lights)I think you are asking about a computer. There are a couple. PCM- engine, ABS-antilock brakes, Airbag - safety restraints, Cluster, Front controller (part of under hood fuse box, runs lights)
In a 2003 Renault Megane, the interior door lights are typically operated by the fuse labeled "Interior Lights" or "Cabin Lights." This fuse is usually located in the fuse box, which can be found under the dashboard or in the engine compartment, depending on the specific model. Always refer to the owner's manual for the exact fuse designation and location to ensure accuracy.
There's a solinoid in the transmission.Suggest to check that first. Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
To reset the airbag and seat belt lights on an Infiniti J30, first, ensure that the ignition is turned off. Then, locate the airbag diagnostic connector under the driver's side dashboard and use a jumper wire to connect the two terminals. Turn the ignition key to the "On" position without starting the engine, and the lights should reset after a few seconds. Remove the jumper wire, turn the ignition off, and then start the engine to check if the lights have turned off.