0
This is probably due to a faulty thermocouple. The thermocouple generates a small voltage when hot that is used as a security device that keeps the gas flowing to the pilot. These are relatively inexpensive (UK about �18).
You can check if this is the problem by measuring the voltage on the wires coming back from the pilot. When you have the red switch depressed, check the voltage (should be about 30mV). If there's no voltage, then change the thermocouple.
The thermocouple will generate up to 50mV in a pilot flame. If it falls below 20mV it should kill the fuel source. It may take a few minutes to generate enough voltage in order to keep the pilot lit, so you may have to depress the button for a minute or more. This would be typical if your unit has been off for an extended period of time.
What else can I help you with?
How can you get the pilot light on a teledyne pool heater to start if you have pressed pilot and the red button?
sit on it then throw it into a creepy cave
How do I reset the electric water heater reset button?
To reset the electric water heater reset button, locate the button on the heater's control panel and press it firmly. This will reset the heater and restore its functionality.
Climate button on the dashboard?
air conditioning and heater control
How can you find a manual for a Teledyne Laars E5520 pool heater?
Try this link www.jandy.com Ken
How do I locate and use the hot tub heater reset button?
To locate and use the hot tub heater reset button, first, look for a control panel near the hot tub. The reset button is usually a small red button on the control panel. Press and hold the reset button for a few seconds to reset the heater. Make sure to follow the manufacturer's instructions for your specific hot tub model.
Where can you get a manual for a teledyne laars series 1 natural gas pool heater?
go to their website and support and download it
How can you contact Teledyne Laars to get a manual for an LLG heater?
I cannot find a current listing for Teledyne Laars. As far as I can tell, Teledyne and Laars separated, Laars joined up with Waterpik and then got reorganized under Jandy. www.jandy.com now has the Laars Lite2 line of pool heaters with the LG model almost identical to the Teledyne Laars LLG. You can access the manual at http://www.jandy.com/pdfs/H02359-.pdf . Jandy also has a parts list for older discontinued models.
How to light a water heater with an electronic pilot by Honeywell?
To light a water heater with an electronic pilot by Honeywell, follow these steps: Locate the control panel on the water heater. Turn the control knob to the "Pilot" position. Press and hold the pilot button while pressing the ignition button. Continue holding the pilot button for about 30 seconds to allow the pilot flame to ignite. Release the pilot button and turn the control knob to the desired temperature setting. Always refer to the manufacturer's instructions for specific details on lighting your water heater.
Where can you obtain an wiring diagram for a EG250 Teledyne Laars gas pool heater?
You might want to try Jandy.com k
How do you wire up a gas valve for a teledyne laarsseries 2 esg175n heater?
Try using the link Jandy.com or Jandy and search from there for manuals for your particular heater model. K
Where is the rear window heater button on a vauxhall corsa 1.4 1998?
On my 1994 Corsa you pull the fan control knob to switch on the rear window heater.
Where can you find a part for a jvt-100c teledyne laars water heater boiler?
You can find every part you need for your boiler at gasboilerspareparts.com
