0
What else can I help you with?
What is the right fuel mix for a 2 stroke outboard motor?
99% of the outboard motors need 50:1
Does a 1963 5HP Gale outboard motor need lead added to the gasoline to run properly?
No.
Where is the water pump located on a 15HP mercury outboard?
The 15 horsepower Mercury outboard motor does not have a water pump. The outboard motor is air cooled and does not have a need for circulating water.
What is the gas oil ratio for a 1988 85 hp force outboard motor?
50:1 you can use any two stroke oil. You don't need to buy the expensive stuff, as they all burn the same.
Do you need a boat license for a 5 hp motor?
do you need a boat licence for a 5hp outboard
Do you mix oil with a two stroke outboard motor?
Gas and oil are mixed on a two-stroke engine, but you don't always have to do it. Some two-stroke outboards have oil tanks and mixing systems that dispense the correct amount of oil for any operating condition; if you have this, you need to check the oil tank every time you add fuel.
How do you remove the lower unit on an outboard motor?
how do u remove the lower uint on an outboard motor? Depends on the outboard. Some Johnson/Evinrudes required that the powerhead (engine) be removed first for example. Look for a service manual for your particular motor on ebay, and it will tell you all you need to know to avoid problems.
What do you need to do to convert a 1995 chevrolet 3500 hd diesel motor to a gasoline motor?
A engine exchange will be necessary. Remove the diesel and install a gasoline type.
What oils do i need to use on 2504x4 polaris xplorer 2 stroke engine?
If it is a 2 stroke then use any brand of 2 stroke oil mixed to the correct ratio with gasoline.
What size of Cranking Marine Battery do you need for your 150 HP outboard motor?
100 aph
Where is the impeller located on an ESKA outboard motor?
The impeller on an ESKA outboard motor is typically located within the water pump assembly, which is situated at the lower unit of the motor. To access it, you usually need to remove the lower unit from the motor. The impeller is housed inside a plastic or metal housing that can be disassembled for maintenance or replacement. Proper care and regular checks of the impeller help ensure optimal cooling and performance of the outboard motor.
What is the gas to oil mixture for a 1980's 2HP Johnson outboard motor?
enough oil is what you need
